カタログ >
Gantner Instruments >
Q.bloxx XE A122

Q.bloxx XE A122
1 / 4ページ

カタログの抜粋

Electromagnetic Compatibility according to EN61000-4 and EN55011 Power supply 10 ... 30 VDC and DIN rail mounting (EN60715) Q.bloxx XE is a new addition to the Q.series product family - the ideal EtherCAT DAQ solution for widely distributed installations that require higher performance and custom sensor terminations. Q.bloxx XE measurement modules possess integrated signal conditioning and arithmetic functions, packaged in modular, DIN Rail mountable enclosures that easily snap together for system expansion and are capable of measuring up to 100 kHz per channel with short cycle times and low jitter for accurate synchronization. ■ RS-485, 2-wire, EtherCAT (LVDS) ■ FoE (file access over EtherCAT, ETG.1000.5) and CoE (CAN over EtherCAT, ETG.50001.1) ■ Configurable PDO mapping to optimize the data throughput Key Features ■ 2 voltage input channels 1 inputs for voltage measurement measuring ranges ±40 V, ±120 V, ±400 V, ±1200 V 1 inputs for current measurement via shunt resistors measuring ranges ±80 mV, ±240 mV, ±800 mV, ±2400 mV ■ Signal conditioning linearization, digital filter, average, scaling, min/max storage, RMS, alarm Fast high accuracy digitalization 19 bit SAR ADC, 100 kHz sample rate per channel ■ Galvanic isolation channel to channel to power supply and to interface isolation voltage 1200 VDC / 848 VACrms test voltage 5 kVDC over 1 minute Categories 1000 V CAT II and 600 V CAT III

カタログの1ページ目を開く

Gantner instruments Q.bloxx XE A122 Module for Measuring Electrical Power Technical Data Analog Inputs Channels 1 according to EN 61326 2006: appendix B 2 according to EN 61326 2006: appendix A Measurement Mode Voltage

カタログの2ページ目を開く

Gantner instruments Q.bloxx XE A122Module for Measuring Electrical Power Measurement Mode Current

カタログの3ページ目を開く

Gantner instruments Q.bloxx XE A122 Module for Measuring Electrical Power - Attention High voltage device, Danger for life and health in case of non regular use. - Only special and sufficient educated persons are permitted to handle this device only. - all metal housing parts must be safely and continuous connected to protected earth (PE) - Only contact protection plugs and cables may be used. All parts must be approved for voltages up to 1200 VDC. - During installation, the whole system must be without voltage and safely be disconnected from the mains. - All relevant safety regulations...

カタログの4ページ目を開く

Q.bloxx XE A122 1 / 4ページ

カタログの抜粋

Gantner Instrumentsのすべてのカタログと技術パンフレット

Q.bloxx XE A122
1 / 4ページ