Manual flox[on] B
1 / 8ページ

MANUAL MASS FLOW CONTROLLER

P e r f ect C o n t rol The flox[on] B is designed for small gas flows between 0.5 and 250 Nlmin-1 under operating pressures of up to 16 bar. The measurement of the gas flow is based on principles of thermal anemometry. The mass flow is regulated by means of a technically sophisticated pressure-compensated proportional valve, which operates independently of pressure fluctuations at the in- and outlets. Manufactured with Swiss precision, these devices have a long operating life expectancy, even under the harshest industrial conditions. They are also maintenance-free, easy to operate and...

3 Outlet flange with thread connection 5 6 4 Inlet flange with thread connection 5 Micro-processor board 6 M8 Power supply 7 M12 Analog connector 8 LED operating mode 9 Measuring cell 10 Filter

Im porta n t data data Minimum flow Maximum flow Maximum operating pressure Operating temperature Regulation ratio Real Value Real Value Connection voltage Flange connector Connection analog Sinter filter Signal Set/Real Bypass signal

connection assignment Ready In operation Fully open Fault

Gas e s a n d ca l ibrati on Before delivery, the measuring cell in every flox[on] B is calibrated with atmospheric air. There are correction factors for applications using other gases. In individual cases, if desired by the client, the calibration can be made directly with the specific gas intended for use. If a mixed gas such as air or natural gas is used, it should be noted that a change in the composition of the gas can occur during operation. In such cases, and for all other questions about calibration, please contact our service center (see back page of this manual). The measuring...

im portant Notic e s Not e s on insta llati o n To ensure trouble-free operation, the flox[on] B should be installed in a horizontal position. If installed vertically, the device could produce faulty measurements under certain conditions. Warning notices When delivered, the flox[on] B comes in secure transport packaging. It can be stored under dry conditions for up to two years before installation. ● The flox[on] B is intended solely for use with gases. ● Liquids will ruin the measuring cell. This includes gas condensation, for example, if temperatures during operation drop below the...

FCTechnik M a ss Flow c o n t r olle r FC Technik AG St. Gallerstrasse 340 CH-8409 Winterthur www.fc-technik.ch info@fc-technik.ch October 2013 | ll information is provided in best conscience. Some clients may desire certain modifications which lead to results other than those found in this manual. A