カタログ >
CRE TECHNOLOGY >
gensys compact prime case study en a2018

gensys compact prime case study en a2018
1 / 2ページ

カタログの抜粋

gensys compact prime case study en a2018 - 1

Production power plant APPLICATION with GENSYS COMPACT PRIME AFRICA - CAMEROUN On applications where several gensets are paralleled in a unique & permanent production power plant, it is proven that simplicity is often closely related to efficiency. It is therefore necessary to get a user-friendly system, with easy access to important information and commands, to reduce local operator mistakes and facilitate fast site support. Production power plants are requiring also a smart management of the gensets to optimize the number of online machines supplying electricity, to optimize maintenance cycles and running hours counters, and to reduce fuel consumption as well as greenhouse gases. GENSYS COMPACT PRIME with cyclic genset running, and load dependent start/ stop On the presented case, each genset is equipped with a GENSYS COMPACT PRIME, all connected by CAN bus using CRE Protocol. Controllers are setup to ensure smart automatic start & stop depending on load demand, with specific start/stop thresholds adjusted to fulfill engine manufacturer requirement for an optimized use. Gensets will then always run between 45% and 75% of their nominal load, with a majority of operation time at 67%. In order to reach the higher efficiency, CRE has recommended the cyclic running feature to automatically stop running gensets after predefined running hours’ time and synchronize standby gensets without any impact on the power plant, this feature will reduce stress on the machine and make sure maintenance cycles are respecting regular periods. Thanks to the combination of CRE smart & standard features, the fuel economy estimation on site is around 8600 liters/year, and the maintenance cycle hours saving is about 400h / year. CRE TECHNOLOGY equipment used: • 5 x GENSYS COMPACT PRIME • 5 x Battery chargers BPRB0524M CRE CONFIG Configuration software CRE TECHNOLOGY free PC software allows you to connect to every CRE TECHNOLOGY modules. This user-friendly software is made to configure and monitor your power plant in real time. • CRE CONFIG software is also providing the possibility to upload/donwload files (config, loggers, firmwares), and to customize your application. CRE TECHNOLOGY - 130, allée Charles-Victor Naudin - Zone des Templiers - SOPHIA ANTIPOLIS - 06410 BIOT - FRANCE Phone : + 33 (0)4 .92.38.86.82 - www.cretechnology.com - info@cretechnolo

カタログの1ページ目を開く

gensys compact prime case study en a2018 - 2

EXPERT IN GENERATOR SOLUTION CRE TECHNOLOGY 130 allée Charles-Victor Naudin - Les templiers - Sophia Antipolis 06410 BIOT / FRANCE Tél: +33 (0) 492 38 86 82 Fax: +33 (0) 492 38 86 83 info@cretechnology.com CASE STUDY POWER PLANT APPLICATION_EN_A2018

カタログの2ページ目を開く