Burst Alert® Sensor
1 / 4ページ

カタログの抜粋

Burst Alert® Sensor - 1

Burst Alert® Sensors For immediate notification of a pressure relief event Visit our website for the most complete, up-to-date information

カタログの1ページ目を開く
Burst Alert® Sensor - 2

Burst Alert® Sensors for Rupture Disks and Other Devices Sensor Type BAS+TM Armored: ABAS+TM Features • Polyimide film • Tantalum conductor wire • Dual path conductor • Reconnect StopsTM • Wide conductor separation Burst Pressures See Table 1 Note: Two Reconnect StopsTM are seen at the breaking ends of the tantalum conductor wire run into the gasket. The stops provide electrical insulation to minimize risk of sensor reconnection after a pressure relief event. Use with the following rupture disk type Sure-Saf Order as EC-Alert Sensor: ECR, ECV, ECT, V/ECR (see table 1) Forward acting...

カタログの2ページ目を開く
Burst Alert® Sensor - 3

Burst Alert® Sensors Sensor Type Features • Polyimide film DASTM TM • Tantalum conductor wire DASS • Dual path conductor Armored: • Domed to accommodate TM ADAS disk dome TM ADASS Use with the following rupture disk type XT, XB, XN-85S and XN disks 4 inches (100mm) and larger used in NX-7R or NXV-7R safety heads. B, BV, Tension D, DV, XN-85 disks used in special reduced height loaded disks safety heads that do not enclose the disk dome. Atmospheric vent type disks: AV, AVV, AVE, AVEL Burst Pressures The response pressure capability of the DAS family of sensors matches the minimum burst...

カタログの3ページ目を開く
Burst Alert® Sensor - 4

Operation / Electrical Information Burst Alert Sensors operate in a “normally closed” electrical circuit with a polymer membrane supporting its electrical conducting circuit. When the pressure event (disk rupture / valve opening) occurs, the flow (gas or liquid) breaks the tantalum electrical conductor located on the polymer membrane. The electrical status of the sensor changes to “normally open.” The recommended maximum operating limits for Burst Alert Sensors is a current of 500mA, maximum voltage 24 VDC; satisfactory operation can be obtained at a few milliamperes current. Gaskets:...

カタログの4ページ目を開く

BS&B SAFETY SYSTEMSのすべてのカタログと技術パンフレット

  1. Type D

    8 ページ

  2. Rupture Disk

    12 ページ

  3. Corporate Profile

    20 ページ

  4. The VAC-SAF? System

    12 ページ

  5. SURE-SAF? System

    4 ページ

  6. ECO-SAF? System

    8 ページ

  7. BIO-SAF? System

    16 ページ

  8. SmartSystem

    4 ページ

  9. MRB series

    1 ページ

  10. SIGMA, SIGMA EXL

    4 ページ

  11. EXPLOSION VENTING

    4 ページ

  12. AVB

    2 ページ

  13. Nu-Saf Plus

    8 ページ

  14. Type B

    8 ページ

  15. Conversion Factors

    2 ページ

  16. The STA-SAF System

    12 ページ