カタログ >
BinMaster >
SmartBob2 MUCM Brochure

SmartBob2 MUCM Brochure
1 / 2ページ

カタログの抜粋

MUCM SmartBob II Momentum Universal Communication Module Easy Serial Interface to PLC, HMI or DCS Systems SMARTBOB II INVENTORY MANAGEMENT SYSTEM ♦ Proven Technology Reliable & Repeatable measurements Not affected by changing material characteristics Unaffected by dust, temperature, dielectric constant, humidity or angle of repose Minimal contact with material No field calibration or adjustments required Division of Garner Industries 7201 N. 98th Street Lincoln, NE 68507 Fax (402) 434-9133 (402) 434-9102 www.binmaster.com 1-800-278-4241 Brand and product names mentioned in this document are trademarks or registered trademarks of their respective companies. SmartBob II Momentum Universal Communication Module (MUCM) . The standard model allows Modbus serial masters to gather data from BinMaster SmartBob II remotes. The system shown in figure 1.1 shows a Modbus Master (HMI,DCS,or PLC), a SmartBob II MUCM, and eight SmartBob II remotes located on vessels. The Modbus RTU master has an RS-232 port that connects to the MUCM. The SmartBob remotes are connected to the MUCM via a multi-drop RS-485 network, are set for slave addresses 1 through 8, and are mapped to Modbus slave addresses 1 through 8 respectively. The SmartBob II Momentum Universal Communication Module (MUCM) allows a Modbus serial master to gather data from up to 32 BinMaster SmartBob II remotes. The data from each SmartBob II remote is presented as a Modbus Holding Register (4x). Each bob is assigned a unique Modbus slave address. A special Modbus slave address of 247 is provided to initiate a measurement and to give a summary of all the measurements from the SmartBob Remotes in the network. The MUCM may be configured as a Modbus RTU or a Modbus ASCII slave. ModBus Master Power RS-232 Serial Cable SmartBob II Remotes Figure 1.1

カタログの1ページ目を開く

MUCM Simple MUCM Set-Up: Modbus Settings: Figure 2.1 HyperTerminal Setup Device Screen The set-up parameters may be reviewed and modified by connecting a terminal or emulator such as a HyperTerminal to MUCM port 1. The setup device screen will bring up prompts (figure 2.1) for the Modbus slave address and SmartBob Slave address. The MUCM will answer Modbus RTU requests on its RS-232 port that are directed to a Modbus slave address. The setup device screen allows you to add, edit, remove, and perform a test measurement on all the SmartBob II remotes in the system. Figure 2.2 Zapreg32 of...

カタログの2ページ目を開く