RHP-1U Rack System
1 / 9ページ

カタログの抜粋

1600~8000W 1U Distributed Power/Charger System RHP-1 U Rack System S (B)cTOus CBC€ ■ Features • Universal AC input / Full range • 1U profile 19” rack shelf, fitting five 1600W modules up to 8000W with active current sharing • Output voltage and current programmable • Support hot swap (hot plug) • Built-in PMBus protocol • 5 years warranty ■ Applications • Distributed power architecture system • Wireless/telecommunication solution • Electric vehicle or marine charger station • DC UPS or emergency backup • Wastewater treatment system • Electrolysis system ■ Description RHP-1U rack power system and RHB-1U rack charger system are the complete solution for the power distribution utilizing the rack configurationwiththe1Ulow profile.Startingwithasingleunit of 1600W, RCP-1600 is the front end rectifier (or, power supply) and RCB-1600 is the charger module. With the active current sharing function, up to 8000W is able to be provided by 1 stack of the 19” rack mountable shelf RHP-1 U, with either rectifier or charger, and 24000W by 3 stacks with rectifier. ■ Model Encoding Rack Shelf: Whole System: RHP-8K1U[E-12 T T Output voltage I: AC Inlet (IEC320-C14) T: Terminal block 8K: Maximum wattage with - fully-populated shelf 1 U: Profile of the system „ . (RHP:Power supply system; -Series name , RHB : Charger system) File Name:RHP-1U RACK SYSTEM-SPEC 2016-11-09 Competitive sensor Et power supply solutions worldwide

カタログの1ページ目を開く

1600~8000W 1U Distributed Power/Charger System RHP-1 U Rack System SPECIFICATION - Power Supply System File Name:RHP-1U RACK SYSTEM-SPEC 2016-11-09 Competitive sensor & power supply solutions worldwide PEWATRON

カタログの2ページ目を開く

MW I MEAN WELL I 1600~8000W 1U Distributed Power/Charger System RHP-1U Rack System SPECIFICATION - Charger System MODEL File Name:RHP-1U RACK SYSTEM-SPEC 2016-11-09 Competitive sensor & power supply solutions worldwide

カタログの3ページ目を開く

1600~8000W 1U Distributed Power/Charger System Function Manual 1. Voltage Drop Compensation (Only for power supply system) 1.1 Remote Sense The remote sense compensates voltage drop on the load wiring up to 0.5V. CN2 +V 1 Sense lines should be twisted in pairs 1.2 Local Sense Notice : The +S,-S have to be connected to the +V(signal),-V(signal),respectively, in order to get the correct output voltage if the remote sensing is not used. CN2 +V +S 2. Output Voltage Programming (or, PV / remote voltage programming / remote adjust / margin programming / dynamic voltage trim) ※ In addition to the...

カタログの4ページ目を開く

1600~8000W 1U Distributed Power/Charger System RHP-1 U Rack System 3. Output Current Programming (or, PC / remote current programming / dynamic current trim) ^ The output current can be trimmed to 20~100% of the rated current by applying EXTERNALVOLTAGE. +S & +V, -S & -V also need to be connected on CN1. (Only for power supply system) 4. Remote ON-OFF Control The PSU can be turned ON/OFF together or separately by using the "Remote ON/OFF" function. ON/OFF A ON/OFF B ON/OFF C ON/OFF D ON/OFF E +5V-AUX ON/OFF A ON/OFF B ON/OFF C ON/OFF D ON/OFF E +5V-AUX 5.PMBus Communication Interface...

カタログの5ページ目を開く

1600~8000W 1U Distributed Power/Charger System RHP-1 U Rack System ■ Mechanical Specification gHgxom^koHg>^ QOOQOW File Name:RHP-1U RACK SYSTEM-SPEC 2016-11-09 Competitive sensor Et power supply solutions worldwide

カタログの6ページ目を開く

1600~8000W 1U Distributed Power/Charger System RHP-1 U Rack System ^ LED Status Indicators & Corresponding Signal at Function Pins ◎ For power supply system File Name:RHP-1U RACK SYSTEM-SPEC 2016-11-09 Competitive sensor & power supply solutions worldwide

カタログの7ページ目を開く

1600~8000W 1U Distributed Power/Charger System RHP-1 U Rack System ^ Connector Pin No.Assignment(JK1) : RJ45 8 positions Note.1: Non-isolated signal, referenced to [-V(signal)]. Note.2: Isolated signal, referenced to GND-AUX. File Name:RHP-1U RACK SYSTEM-SPEC 2016-11-09 Competitive sensor Et power supply solutions worldwide

カタログの8ページ目を開く

Headquarter Switzerland: Pewatron AG Thurgauerstrasse 66 CH-8050 Zurich Phone +41 44 877 35 00 info@pewatron.com Office Germany: Pewatron Deutschland GmbH EdisonstraEe 16 D-85716 UnterschleiEheim Phone +49 89 374 288 87-0 info.de@pewatron.com PEWATRON 5ENS0R5 • POWER SOLUTIONS We are here for you. Addresses and Contacts. Sales Germany & Austria Postcode 00000 - 31999 Postcode 38000 - 39999 Postcode 80000 - 99999 Austria Kurt Stritzelberger Phone + 49 89 260 52 80 Mobile + 49 171 803 41 35 kurt.stritzelberger@pewatron.com Geometrical sensors Sensor elements Thorsten Ravagni Phone +49 60 479...

カタログの9ページ目を開く