HX-EP
1 / 6ページ

カタログの抜粋

HX-EP SERIES DIGITAL OUTPUT Utilizing an incremental encoder as the sensor, the HX-EP series position transducer provides a two channel square wave current sinking output signal in quadrature. The standard output is a single-ended TTL compatible square. The resolution values shown in the specifications table indicate resolution for times 1 counting mode where a count is registered for one up transition in channel A. With interface electronics capable of times 2 or times 4 counting mode, a true resolutional increase of 2 or 4 may be obtained. For example, the HX-EP-50 has a resolution of approximately .004" per count in times 1 counting mode whereas the resolution is approximately .001" per count in times 4 counting mode. The actual resolution of a HX-EP transducer differs from unit to unit because of tolerances associated with the wire rope diameter and the capstan upon which the wire rope winds. The nylon jacketed wire rope option will have the effect of slightly reducing the resolution. Linearity and repeatability remain independent of resolution. In applications where the output count is interpreted as a percentage of total travel, resolutional differences from unit to unit are not critical. However, in applications where the digital output is to be interfaced to a digital display to give an output in engineering units, the calibration constant supplied with the transducer may be used to calculate a suitable scale multiplier to produce the correct engineering units. Alternative outputs shown in the Electrical Outputs table below are available to facilitate interfacing to a variety of different types of equipment. ALL RANGES GREATER THAN 100” ELECTRICAL OUTPUT For electrical output description, waveform and wiring, See Standard Series Supplemental Data, TABLE 8. FOOTNOTES TO SPECIFICATIONS 1. Supplemental Data section located at end of HX Series pages. 2. The resolution shown is a calculated number based upon the capstan diameter, wire rope diameter and line count of the encoding device. The tolerance on the resolution accounts for resolutional differences from unit to unit due to manufacturing tolerances on the capstan and wire rope. In practice, the output count in a given unit of travel is an integer. MODEL NUMBER CONFIGURATION Basic Configuration (See Supplemental Data, Table 12) WIRE ROPE EXIT DIRECTION U se Number designators shown ELECTRICAL OUTPUT INGRESS PROTECTION For Description See Supplemental Data, TABLE 8 NOTES FOR OPTION BOXES 7 , 8, and 9 (NEMA 4): Transducer equipped with body mounted connector and with or without mating connector. Mating connector with electrical cable available separately as part number 10119-xM where ‘x’ is length of electrical cable in meters. IP-68–NEMA 6 CABLE MOUNTED CONNECTOR (NEMA 6): Transducer equipped with bulkhead fitting and length of electrical cable. Remote end of electrical cable may be outfitted with water proof connector. Mating connector with electrical cable available separately as part number 10424-xM where ‘x’ is length of electrical cable in meters.

カタログの1ページ目を開く

SUPPLEMENTAL DATA OPTION DESCRIPTIONS OPTION OPTION DESIGNATOR Replaces standard stainless steel wire rope with Ø.018 nylon jacketed wire rope. This option increases wire rope life dramatically but may increase non-linearity by as much as ±.05% of full scale. Replaces standard stainless steel wire rope with Ø.037 nylon jacketed wire rope. WIRE ROPE NYLON JACKETED WIRE ROPE RANGES TO 80” ONLY NYLON JACKETED WIRE ROPE RANGES 100" TO 500" ONLY WIRE ROPE EXIT DIRECTION ALTERNATE WIRE ROPE EXIT RANGES TO 80” (2.0 m) (dimensions in brackets are millimeters) ALTERNATE WIRE ROPE EXIT RANGES 100”...

カタログの2ページ目を開く

ADDITIONAL OPTIONS EP, HX-EP SERIES OPTIONAL ELECTRICAL OUTPUTS OUTPUT DESCRIPTION 5 VDCTTL compatible open collector current sinking output. Two channels with optional index channel available. 11 is same as Option 10 but adds the index (Z) channel. Current sinking output with 10KQ internal pullup resistors 8 to 28 VDC input voltage. 51 is same as Option 50 but adds the 5 VDC Push-Pull Differential Line Drive Push-Pull, current sourcing and current sinking output. 5 VDC input voltage. Output is compliant with requirements of TIA/EIA- 422-B. 31 is same as Option 30 but adds the index (Z)...

カタログの3ページ目を開く

SUPPLEMENTAL DATA MECHANICAL SPECIFICATIONS Stainless Steel & Anodized Aluminum Housing High Impact, Corrosion Resistant Thermoplastic Housings 1. With 1K ohm potentiometer, wire rope misalignment 2° maximum at full stroke, relatively dust free environment, nylon jacketed wire rope on units with ranges 80" and less. Use value from this column to indicate over- Check mark indicates available measurement range Product Photo Specifications subject to change without notice Supporting your great ideas a member of the Angst + Pfister Group

カタログの4ページ目を開く

SUPPLEMENTAL DATA DIMENSIONAL INFORMATION HX SERIES RANGES 80" (2 m) OR LESS HX SERIES RANGES GREATER THAN 80" (2 m) JN MODELS WITH ZERO AND SPAN :DNTREILS, REMOVE SELF SEALING SCREWS TE ACCESS ADJUSTMENT ^MOUNTING SURFACE [dimensions in brackets are millimeters] 1. Transducer mounts with 0.25 or M6 socket head cap bolts EN MEDELS WITH ZERE AND SPAN CONTROLS, REMOVE SELF SEALING SCREWS TE ACCESS ADJUSTMENT 1. Transducer mounts with 0.50 or M12 socket head cap bolts, 2. Dimension "C" is the cable offset that occurs as the cable is extended from the transducer. For "C" in inches, C = .0016 x...

カタログの5ページ目を開く

We are here for you. Addresses and Contacts Sales Switzerland & Liechtenstein Sales International Key Accounts Matthias Rüegg Ruhbergstrasse 32 CH-9230 Flawil Peter Felder Thurgauerstrasse 66 CH-8052 Zürich Sales Austria Sales Germany Postcode 10000 –59999 Postcode 80000 –99999 Kurt Stritzelberger Neumarkter Str. 86a D-81673 Munich Dieter Hirthe Auf der Entenweide 4 69502 Hemsbach Kurt Stritzelberger Neumarkter Str. 86a D-81673 Munich Sales Other Countries / Product Management Sensors Power Supplies Physical Sensors Data Acquisition DC-DC Converters Switching Power Supplies DC-AC Inverters...

カタログの6ページ目を開く

HX-EP 1 / 6ページ

カタログの抜粋

Angst+Pfister Sensors and Power AGのすべてのカタログと技術パンフレット

HX-EP
1 / 6ページ