カタログ >
4B Braime Components >
4B Binswitch - Capacitance Point Level Switch

4B Binswitch - Capacitance Point Level Switch
1 / 2ページ

カタログの抜粋

4B Binswitch - Capacitance Point Level Switch - 1

Capacitive Proximity Sensor APPLICATION Detects level or plug situations in bulk granular solids or liquids. Can also be used for misalignment monitoring on a conveyor or elevator. METHOD OF OPERATION The Binswitch Sensor detects level or plug situations for bulk granular solids or liquids in tanks, bins, or silos and can be used as a plug or choke detector in chutes, conveyors and elevator legs. Programmable features include time delay on material arriving or leaving, and failsafe relay settings for high and low levels. A two colour LED shows material present or absent and flashes red or green to show the time delay is operating. The programmable sensor operates on 12-240 VAC/DC and gives a changeover relay contact output. The polycarbonate housing is corrosion and abrasion resistant, dust-tight, and waterproof. Product Information FEATURES t Universal Voltage ■■ Adjustable Sensitivity ■■ 25mm detection range ► Certified to ATEX & lECExClass 2 Division 1 Groups E, F & G Approved k IP65 Protection: Totally Sealed Construction PART NUMBERS/ACCESSORIES ■■ BS12V10AI 2-Wire Binswitch High Level Fail Safe ► BS15V10AI 5-Wire Binswitch High Level Fail Safe k- BS22V10AI 2-Wire Binswitch Low Level Fail Safe k- BS25V10AI 5-Wire Binswitch Low Level Fail Safe k- BAS2 Binswitch Abrasion Shield k- BTAS1 Teflon Abrasion Shield End Cap k TMP Top Mounting Plate k- SMP Side Mounting Plate k- BMPA 1-1/4” NPT Mount Plate Adaptor k- BAS Polyurethane Abrasion Shield 1-1/4" NPT k- KIT CAPA Adjustable level from 0,65 to 2,05 meters BAS2 Abrasion Shield Please refer to instruction manual for correct installation. Information subject to change or correction. September 2011

カタログの1ページ目を開く

4B Binswitch - Capacitance Point Level Switch - 2

Product Information TECHNICAL SPECIFICATIONS Type Power Supply Approvals Contact Max. Frequency Protection Sensitivity Volt drop Cable Calibration Capacity Ambiant Temperature 24-240 Vac/dc 12-240 Vdc 24-240 Vac ATEX EX II 1D T100°C (Zone 20) IECEx Zone 20 & CSA Normally Closed Normally Open Normally Closed Normally Open 4 Hz IP 65 Detects up to 25 mm 8 V max. 2 wires, 5m or 10m cable 5 wires, 5m or 10m cable Turn sensitivity adjustment screw; the silo must be empty for calibration 200 mA Max. Changeover relay rated at 3A 240Vac. Non inductive -15° to + 50°C Black/orange Relay output 3A...

カタログの2ページ目を開く