video corpo

WE-SECF SMD EMI Contact Finger
5Pages

{{requestButtons}}

Catalog excerpts

WE-SECF SMD EMI Contact Finger - 1

more than you expect B Recommended land pattern: [mm] Recommended compression: WURTH ELEKTRONIK This electronic component has been designed and developed for usage in general electronic equipment only. This product is not authorized for use in equipment where a higher safety standard and reliability standard is especially required or where a failure of the product is reasonably expected to cause severe personal injury or death, unless the parties have executed an agreement specifically governing such use. Moreover Wiirth Elektronik eiSos GmbH & Co KG products are neither designed nor intended for use in areas such as military, aerospace, aviation, nuclear control, submarine, transportation (automotive control, train control, ship control), transportation signal, disaster prevention, medical, public information network etc.. Wiirth Elektronik eiSos GmbH &Co KG must be informed about the intent of such usage before the design-in stage. In addition, sufficient reliability evaluation checks for safety must be performed on every electronic component which is used in electrical circuits that require high safety and reliability functions or performance.

Open the catalog to page 1
WE-SECF SMD EMI Contact Finger - 2

more than you expect Feeding direction- Packaging is referred to the international standard IEC 60286 -3:2007 WURTH ELEKTRONIK Tape width Pull-of force WE-SECF SMD EMI Contact Finger Wiirth Elektronik eiSos GmbH & Co. KG WORTH ELEKTRONIK This electronic component has been designed and developed for usage in general electronic equipment only. This product is not authorized for use in equipment where a higher safety standard and reliability standard is especially required or where a failure of the product is reasonably expected to cause severe personal injury or death, unless the parties have...

Open the catalog to page 2
WE-SECF SMD EMI Contact Finger - 3

more than you expect H1: Classification Reflow Profile for SMT components: Max. Ramp Down Rate = 6°C/s Preheat Area H2: Classification Reflow Profiles WURTH ELEKTRONIK H3: Package Classification Reflow Temperature This electronic component has been designed and developed for usage in general electronic equipment only. This product is not authorized for use in equipment where a higher safety standard and reliability standard is especially required or where a failure of the product is reasonably expected to cause severe personal injury or death, unless the parties have executed an agreement...

Open the catalog to page 3
WE-SECF SMD EMI Contact Finger - 4

I Cautions and Warnings: The following conditions apply to all goods within the product series of WE-SECF of Würth Elektronik eiSos GmbH & Co. KG: General: All recommendations according to the general technical specifications of the data sheet have to be complied with. The responsibility for the applicability of customer specific products and use in a particular customer design is always within the authority of the customer. All technical specifications for standard products do also apply for customer specific products. Product specific: Follow all instructions mentioned in the datasheet,...

Open the catalog to page 4
WE-SECF SMD EMI Contact Finger - 5

J Important Notes: The following conditions apply to all goods within the product range of Würth Elektronik eiSos GmbH & Co. KG: 1. General Customer Responsibility Some goods within the product range of Würth Elektronik eiSos GmbH & Co. KG contain statements regarding general suitability for certain application areas. These statements about suitability are based on our knowledge and experience of typical requirements concerning the areas, serve as general guidance and cannot be estimated as binding statements about the suitability for a customer application. The responsibility for the...

Open the catalog to page 5

All Würth Elektronik eiSos catalogs and technical brochures

Archived catalogs