video corpo

Weishaupt Monarch oil burners Sizes 1 and 3 - 16 Pages

  1. P. 1

  2. P. 2

  3. P. 3

  4. P. 4

  5. P. 5

  6. P. 6

  7. P. 7

  8. P. 8

  9. P. 9

  10. P. 10

Catalogue excerpts

Weishaupt Monarch oil burners Sizes 1 and 3

 Open the catalogue to page 1

Weishaupt Monarch oil burners are of the fully automatic pressure atomising type. Their design has been carefully considered down to the smallest detail and has been proved successful over and over again. They meet all the demands for safety, reliability and low cost servicing. Weishaupt oil burners variety of interesting features: ■ Automatic sequence of operations ■ Stable fan characteristics - good combustion results ■ Air regulation on pressure side ■ Air damper closed on burner shut- ■ Complete pre-wired integral switch- ■ Hinged burner casing ■ Combustion head can be withdrawn when the burner...

 Open the catalogue to page 2

Monarch L distillate oil burner, two stage Integral switchgear (distillate oil burner) Monarch M residual oil burner, preheater side Pressure side air regulation Monarch RL distillate oil burner, compound regulator side Combustion head removable from behind Monarch RL distillate oil burner, regulating drive 3

 Open the catalogue to page 3

Included in delivery Industrial version Included in burner delivery L1Z-B L3Z-A (LN) L1T-B L3T-A M1Z-B M3Z-A RL3-A Burner casing with integral air inlet, hinged flange, hinge interlock switch, flange gasket, Weishaupt burner motor, fan, pump, oil hoses, nozzle assembly, combustion head, ignition transformer, ignition cables, ignition electrodes, fixing screws, air damper on fan pressure side. ● ● ● ● ● Oil solenoid valve(s) ● ● ● ● ● Additional safety valve(s) and oil pressure switch (on burners >30 kg/h) ● – ● – ● – ● ● ● ● Nozzles(s) ● ● ● ● ● Burner controller with flame sensor – Type LOA for...

 Open the catalogue to page 4

Model overview Quick regulation Weishaupt Monarch oil burners slow (sliding) regulation three stage Two stage and three stage Standard execution burner ■ Oil is released at start when solenoid valves 1 and 2 open. The burner works at partial load. ■ Full load is reached when solenoid ■ The capacity is regulated by opening and closing solenoid valve 3 or 3 Sliding two stage and modulating ■ For burner start the oil regulator goes into the 'ignition load' position. ■ A slow running oil / air compound servomotor adjusts the oil quantity up to full load. The servomotor regulates the burner capacity...

 Open the catalogue to page 5

Size 1 burner selection Burner rating / combustion chamber pressure Combustion head type Burner type Combustion head type Burner type _ Combustion head

 Open the catalogue to page 6

Burner type _ Combustion head combustion chamber resistances are maximum values, which were measured to EN 267 on idealised test flame tubes. All ratings data given relate to an air installation height above sea level of The oil throughput information refers All burners with an oil throughput > 30 kg/h are equipped with a second solenoid valve (safety valve) as standard. The burners are supplied with single phase 230 V, 50 Hz supply (E), or three standard. Please indicate other voltages and frequencies required (no extra price) Burner motor standard version Btrop class insulation, to IP54, F class The...

 Open the catalogue to page 7

Size 3 burner selection Burner rating / combustion chamber pressure Burner type Combustion head Burner type Combustion head

 Open the catalogue to page 8

Burner type Combustion head type combustion chamber resistances are maximum values, which were measured to EN 267 on idealised test flame tubes. All ratings data given relate to an air installation height above sea level of The oil throughput information refers All burners with an oil throughput > 30 kg/h are equipped with a second solenoid valve (safety valve) as standard. The burners are supplied with single phase 230 V, 50 Hz supply (E), or three standard. Please indicate other voltages and frequencies required (no extra price) Burner motor standard version Btrop class insulation, to IP54,...

 Open the catalogue to page 9

Order numbers, technical information Nominal capacity Motor pre-fuse Version ZME without integral switchgear © - Version ZMD without integral switchgear © - Nominal capacity Motor pre-fuse Burner controller Ignition transformer © A separate control panel is required on (operation without continuous supervision). The integral switchgear is therefore omitted. © On burners without integral switchgear, the burner controller is supplied loose. It can be mounted on the burner at extra cost (see page 1 2). A terminal strip is provided in both cases. can be used with this specification up to 30 kg/h....

 Open the catalogue to page 10

Burner fuel systems Monarch RL3-A sliding two stage and modulating burner without shut off 1 Pump without inbuilt solenoid valve 2 Pump with two inbuilt solenoid valves 4 Normally closed solenoid valve 4a Normally open solenoid valve 5 Normally closed solenoid valve (1 st shut off device in supply line 115 V, electrically connected in series) 5a Normally closed solenoid valve (1 st shut off device in return line 115V, electrically connected in series - fitted against direction of flow) 6 Normally closed solenoid valve (2nd shut off device in supply line 6a Normally closed solenoid valve (2nd shut...

 Open the catalogue to page 13

0) For version E/version D © For combustion head M2/1 a, M5/2a

 Open the catalogue to page 14

Weishaupt control panels Weishaupt control panels for • three stage burners • sliding two stage burners The basic control panels contain all burner controls, that means all inbuilt switchgear necessary for the operation Weishaupt control panels conform to applicable national/international Switching includes • Power supply • Burner control • Door mounted switches • Door mounted indicating lamps Individual customer requirements can be • Boiler installations • Thermal process equipment • Ships execution • Building management systems Together with ist core business of burners and heating systems, Weishaupt...

 Open the catalogue to page 15

Product and customer service- the complete Weishaupt range Max Weishaupt GmbH, D - 88475 Schwendi Printed in Germany. All rights reserved. Abbey House, 18-24 Stoke Road, Slough Neachells Lane, Willenhall Regular maintenance reduces heating costs and environmental pollution. Only a properly adfusted burner can save enegy end be environmentally friendly. Behind each Weishaupt customer service organisation. The outstanding efforts made in maintenance and service justify the enormous trust places in Weishaupt's burners, for at Weishaupt product and customer service belong Weishaupt customer service...

 Open the catalogue to page 16

All Weishaupt catalogues and technical brochures

Archived catalogues