SONOPOWER - ultrasonics generators
SONOPOWER T/SP - 22604 Notes on our transducer systems:
Please also observe the safety instructions!
Maximum cable length:
15 meters Special lengths can be used following consultation with our Sales Department.
www.weber-ultrasonics.com
Cleaning medium:
Viscous media with a dynamic viscosity of >1000 mPAs at room temperature may not be used.
Bending radius of the stainless steel hose:
The minimum bending radius of the stainless steel hose is 32 mm. Tighter radiuses will irreparably damage the stainless steel hose.
Minimum distances (spacing) of the transducer system:
Minimum distance to the surface of the liquid: 50 mm
Minimum distance to heating elements: 50 mm
Minimum distance between two facing
transducers: 200 mmThe surface of the
transducer must be treated with care. Scratches accelerate the appearance of pitting corrosion and shorten the service life.
Special notes on rod-style transducers:
Rod-style
transducers made of titanium alloy are not resistant to hydroxides or inorganic acids and their salts.
Temperature resistance:
HD series: up to 95°C Non-HD models: up to 85°C
Maximum pressure: 10 bar
Rod-style
transducers should never be operated dry. Should they repeatedly be operated dry at short intervals, this can damage the
transducers irreparably.
Special notes on submersible transducers:
The inside of the
transducer must be protected from moisture. The
transducer must be attached to the mounting fixtures provided. No additional boreholes may be drilled, as this can lead to irreparable damage and also invalidates the warranty.
Maximum pressure: 0.3 barMaximum negative pressure: 0.1 bar
The liquid in which the
transducers are located may only contain chemicals that do not attack stainless steel 1.4571. The maxi-mum chloride content of this liquid may not exceed 40 ppm, as pitting corrosion may otherwise occur. Should you have other corrosion protection requirements, please get in touch with our Sales Department.
19
