Digital Length Gauges
5Pages

{{requestButtons}}

Catalog excerpts

Digital Length Gauges - 1

- Measurement range up to 25 mm - Linearity 0.2 pm - TTL or 1 Vpp - IP50 or IP64 - Spring guide - Plunger actuation by measured object or pneumatic - Working temperature: + 10 °C to +40 °C

Open the catalog to page 1
Digital Length Gauges - 2

TECHNICAL DATA Mechanical data Measuring range Plunger actuation By cable or measured object Position of plunger at rest Measuring standard DIADUR phase grating on Zerodur glass ceramic; grating period 4 μm System accuracy Position error per signal period Short-range accuracy typically Reference mark Working pressure Radial force approx. 1.7 below upper stop - Operating orientation Working temperature Mass without cable Electrical data Signal period Mech. permissible traversing speed Integrated interpolation Edge separation a at scanning frequency*/traverse speed 50 kHz ≤ 6 m/min 25 kHz ≤ 3...

Open the catalog to page 2
Digital Length Gauges - 3

mm £3# Tolerancing ISO 8015 ISO 2768 - m H < 6 mm: ±0.2 mm ® = Reference mark position © = Beginning of measuring length © = Clamping area © = Air connection for 2 mm tube

Open the catalog to page 3
Digital Length Gauges - 4

GAUGING FORCE / PATH DIAGRAM

Open the catalog to page 4
Digital Length Gauges - 5

WayCon encoders with TTL interface incorporate electronics that digitize sinusoidal scanning signals with or without interpolation. The incremental signals are transmitted as the square-wave pulse trains Ua1 and Ua2, phase-shifted by 90° elec. The reference mark signal consists of one or more reference pulses Ua0, which are gated with the incremental signals. In addition, the integrated electronics produce their inverted signals Ua1, Ua2 and Ua0 for noise-proof transmission. The illustrated sequence of output signals - with Ua2 lagging Ua1 - applies to the direction of motion shown in the...

Open the catalog to page 5

All WayCon Positionsmesstechnik GmbH catalogs and technical brochures

  1. LVIG SERIES

    5 Pages