Barrel Heaters
THINBAND Mica
Type E Type H >
Barrel Heater Terminations
Stock LA Option Stock LA Option Continued >
8 mm(0.30 in.) 10 mm(0.38 in.) Type E and length. Loose metal braid encloses twofiberglass leads for good abrasion
protection, lead flexibility and wiring
convenience. Leads are 51 mm (2 in.) longer than the braid.To order,
specify A stainless steel, flexible conduitenclosesthe leads for superiormechanical protection where leadabrasion is a particular problem.
Leads are 51 mm (2 in.) longer than the conduit.To order, specify Type H uninsulated ground wire and length. or terminal stud. 18 gauge uninsulated ground wire is available on all lead types except post terminals and Type C
leads. A 10-24 ground terminal stud has a threadedlengthof 17mm (1.0625in.). Studs are weldedto the sheath and are provided with
a green nut and washer. To order,
specify Type L >
Stock Option • One to four inch diameter
• One to six inches wide
Ground Wire or Terminal Stud Type L. >
34 mm 8-32 x (1.3125 in.) long S.H.C.S. Type A. Flexible lead wires with fiberglasssleeves exit the nozzle heater on
both sides of the gap. The heatersheath encloses the ends for protection against contamination.
To order, specify >
13 mm(0.5 in.) 12 mm(0.4375 in.) Type A Stock Option >
25 mm - 102 mm(1 in. - 4 in.) Diameter Especially designed for nozzleheaters. A galvanized metal braid
over the fiberglass insulated leads
provides strength and protection.
The heater ends are enclosed to
protect against melted plastic andcontaminants. This arrangement per-mits 25 mm (1 in.) and wider nozzle
heaters to be placed flush against a
flange. Available on nozzle sizes
only. To order, specify >
3 mm(0.0937 in.) See page 38 forminimum/maximumdimensional requirements. 44 >