catalogue search
P. 01
P. 02
P. 03
P. 04
P. 05
P. 06
P. 07
P. 08
P. 09
P. 10
P. 11
P. 12
P. 13
P. 14
P. 15
P. 16
P. 17
P. 18
P. 19
P. 20
P. 21
P. 22
P. 23
P. 24
P. 25
P. 26
P. 27
P. 28
P. 29
P. 30
P. 31
P. 32
P. 33
P. 34
P. 35
P. 36
P. 37
P. 38
P. 39
P. 40
P. 41
P. 42
P. 43
P. 44
P. 45
P. 46
P. 47
P. 48
P. 49
P. 50
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
You may also be interested in
Thermocouple wire, Power regulator, Resistive temperature detector, Controller, Band heater
Text version of the page
| Barrel Heaters | ||||||||||||||||||||||||||||||
| THINBAND Mica Barrel Heater Clamping Variations Tig Welded Barrel Nuts With Spring Loaded Clamping | ||||||||||||||||||||||||||||||
| Refer to the THINBAND recommended clamping graph on page 39. This option is mandatory on vertical applications. To order, specify spring loaded clamping. | ||||||||||||||||||||||||||||||
| Tig welded barrel nuts with spring loaded clamping are used during start-up to maintain a tight heater fit on large barrels. Stainless steel top metal is required. | ||||||||||||||||||||||||||||||
| Tig Welded Barrel Nuts An ideal way to provide access for instrumentation is to specify an oversized gap between the heater ends. If the THINBAND clamp bar screw interferes with the positioning of the instrumentation device, | ||||||||||||||||||||||||||||||
| tig welded barrel nuts are recommended. Stainless steel top metal is required. Maximum gap is 25 mm (1 in.). Specify tig welded barrel nuts and gap dimension when ordering. | ||||||||||||||||||||||||||||||
| 14 mm (0.563 in.) | ||||||||||||||||||||||||||||||
| Tig Welded | ||||||||||||||||||||||||||||||
| Non-Stock Option | ||||||||||||||||||||||||||||||
| Clamping Pads Clamping pads are used when an obstruction would prevent a standard full circumferential heater from fitting completely around a | ||||||||||||||||||||||||||||||
| machine barrel. The clamping pads have a hole to allow easy fastening to the machine barrel. Dimensional drawing required when ordering. | ||||||||||||||||||||||||||||||
| Variations | ||||||||||||||||||||||||||||||
| Non-Stock Option | ||||||||||||||||||||||||||||||
| An economical way to provide nearly any location as long as access for instrumentation is to there is at least 25 mm (1 in.) specify an oversized gap between between the hole and one side of the heater ends. A hole in the sheath the heater. Standard hole sizes up should be specified only when all the to 51 mm (2 in.) diameter. Consult cylinder surface adjacent to the hole factory for limitations. For proper must be heated. When required, hole location, a dimensional drawing one hole may be provided in is required. | ||||||||||||||||||||||||||||||
| 40 | ||||||||||||||||||||||||||||||