| | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | |
| | | |
| | | and Heaters | | |
| | | |
| | | THINBAND Mica Barrel and Nozzle Barrel Heater Terminations Continued | | |
| | | Type E Stock LA Option | | Type H Stock LA Option | | |
| | | |
| | | |
| | | Loose metal braid encloses two fiberglass leads for good abrasion protection, lead flexibility and wiring convenience. Leads are two inches (51 mm) longer than the braid. To order, specify Type E and length. | | A stainless steel, flexible conduit encloses the leads for superior mechanical protection where lead abrasion is a particular problem. Leads are two inches (51 mm) longer than the conduit. To order, specify Type H and length. | | |
| | | W o> 3 a. | | |
| | | |
| | | x CD fi) CD | | |
| | | |
| | | |
| | | |
| | | 18 gauge uninsulated ground wire is available on all lead types except post terminals and Type C leads. A 10-24 ground terminal | | stud has a threaded length of 1Xa inch (17 mm). Studs are welded to the sheath and are provided with a green nut and washer. To order, specify uninsulated ground wire or terminal stud. | | |
| | | |
| | | |
| | | THINBAND Nozzle Heater Terminations • One to four inch diameter • One to six inches wide | | |
| | | Type L Stock Option | | |
| | | |
| | | |
| | | 8-32 x 15/16" (34 mm) long S.H.C.S. 7/l6" (12 mm) | | |
| | | Flexible lead wires with fiberglass sleeves exit the nozzle heater on both sides of the gap. The heater | | sheath encloses the ends for protection against contamination. To order, specify Type L. | | |
| | | 1/2" (13 mm) | | |
| | | |
| | | |
| | | |
| | | Type A Stock Option | | |
| | | |
| | | — 3/32" (3 mm) | | |
| | | Especially designed for nozzle heaters. A galvanized metal braid over the fiberglass insulated leads provides strength and protection. The heater ends are enclosed to protect against melted plastic and | | contaminants. This arrangement permits one inch (25 mm) and wider nozzle heaters to be placed flush against a flange. Available on nozzle sizes only. To order, specify Type A. | | |
| | | |
| | | See page 25 for minimum/maximum dimensional requirements. | | |
| | | |
| | | |
| | | |
| | | 31 | | |
| | | |
| | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | |