| | | | | | | | | | | | | | | | | | | | | | | | |
| | | |
| | | | | |
| | | |
| | | Ml Barrel and Nozzle Variations Continued | | |
| | | |
| | | Ml Band Heater With Holes Ml Band heaters with holes are available on all widths except one inch wide. Consult the watlow factory in St. Louis. Missouri ior hole | | |
| | | sizes and location restraints. To order, specify hole size and location. Three inch inside diameter | | |
| | | |
| | | |
| | | Outside Diameter Heater | | |
| | | |
| | | s insulated lead wires rated to 840 °F (450<C) exit a metal braid 180 degrees opposite from gap, Type B outside diameter | | designBd and constructed to mate with inside diameter of cylinders. 1 order, specify outside diameter heater. | | |
| | | |
| | | |
| | | Clamping Variations Tig Welded Barrel Nuts With Spring Loaded Clamping | | |
| | | |
| | | Welded barrel nuts with spring loaded clamping are used during start-up to maintain a tight heater t on large barrels. This clamping variation is standard for all Ml Band heaters that are greater than 14 inches (355 mm) in diameter and | | 1 '7 inches (38 mm) or greater in width. Referto Ml Band damping Matrix Application Guide, page 16. For smaller diameter heaters, it is an option and must be ordered separately. To order, specify spring loaded clamping. | | |
| | | |
| | | Tig Welded Barrel Nuts An ideal way to provide access for instrumental ion is to specify an oversized gap between the heater ends. If the clamp bar screw interferes with the positioning of | | |
| | | ihe instrumentation device, welded barrel nuts are recommended To order, specify tig welded barrel nuts and gap dimension when ordering. | | |
| | | |
| | | Low Profile Tig Welded Barrel Nuts Low pro le barrel nuts are available (10 mm). To order, specify low on all widths. Low pro le barrel nuts profile fig welded barrel nuts, have a clearance of 0.406 inch | | |
| | | |
| | | Low Profile Clamp Bars Low pro le clamp bars are available on both one (25 mm) and Vi inch (38 mm) wide heaters, for wider widfhs consult factory. The bars are | | |
| | | '.i inch (6 mm) diameter with an 8-32 screw To order, specify low profile clamp bars. | | |
| | | |
| | | |
| | | | | | | | | | | | | | | | | | | | | | | | |