Suction Gun - Wandres - #11

For precision-spraying of the Ingromat®T, cooling and separating agent. The sprayer is made to suit even the most arduous industri­al conditions. A special air guide mechanism centralises the spray jet preventing the for­mation of drips and irregular application of Ingromat®T. The sprayer can be installed in any position.

Compressed air 0 6, approx. 2 bar

Ingromat T 0 6

Ingromat T apportioning

Contrary to applying separating agents to the edge before the emer­gence of hot glue, Ingromat®T is applied onto the surplus hot glue residues.

The hot glue residues cool down immediately. They may now be removed easily during the following routing process without spreading the glue onto the edge and without "clogging" the tools. Ingromat®T is environmentally friendly and evaporates without lea­ving traces on the surface. No consequent cleaning is necessary.

Ingromat™T is applied

Ingromat™T cools the surface and evaporates without leaving traces.

The illustration shows a laminated panel after edge banding.

Ingromat® T sprayjet

Linear application of approx. 3 mm of separating and cooling agent Ingromat® T (for illustration purposes, the width is exaggerated and Ingromat T is shown in green)