Text version of the page

Load PinSB-32-50/63-1/2.XX

description

The load pin works according to the strength measuring principle on a transverse basis to the longitudinal axis.The SB-32 was developed especially for strength measuring at traversing wheels, can be, however, used also at pulleys, cranes, lifts or other mechanical force measurement on working platforms.It is executed as a stretching bolt with two clipping chases. Crossways chase is it fixed or the like on a side by a diameter extension and on the other side by two for the mounting device of locking plates against slipping axially. Other safety device for example bags drillings, on enquiry. A side is flat to the protection from twisting and to the identification of the strength introduction.The application cell for the strain gauge has been cast with a high-elastic compound and is thus protected against mechanical or chemical damages.DMS measures the shear stress of the feather body special on recessed double diaphragms. Executions with strap output or amplifier with a measuring signal of 1 - 9 mA or 4 - 20 mA are possible for it.By application of an amplifier the nominal output current can be produced in the unloaded state by add-ons of the calibrating checking signal (software calibration). A check of the load pin with the amplifier and the following measuring facilities is possible with that.The SB-32 is planned according to execution for the direct connection with an amplifier or a control.
2007-09-13technical changes and errors exceptedSB-32_e.cdr