A Simple Approach to Hollow Section Truss Girder Design - 14 Pages

VALLOUREC & MANNESMANN TUBES

Q Q Q

I

A Simple Approach

to Hollow Section

Truss Girder Design

Jurgen Krampen

Vallourec & Mannesmann Tubes,

Dusseldorf, Germany

Lecture held at the

Hilton Hotel, Dusseldorf, Germany

on the occation of the

9th International Symposium

and EuroConference on Tubular Structures

3rd to 5th April 2001

A Simple Approach to Hollow Section Truss Girder Design
  1. P. 1

  2. P. 2

    Jurgen Krampen A Simple Approach to Hollow Section Truss Girder Design When designing hollow section structures, special importance...
  3. P. 3

    2 Validity range The simplified design method introduced here is valid only in conjunction with the use of S 355 J2H steel, and provided certain...
  4. P. 4

    Table 2. Dimensioning truss members Member Compression chord Tension chord Compression bracing member Tension bracing member Design formula Nu...
  5. P. 5

    Joints with only one bracing member are treated as gap joints. Joints with three bracing members are subdivided into two partial joints A and...
  6. P. 6

    5.3 Joint stiffening plates As a rule, hollow section trusses should be so dimensioned that no stiffening plates at all are required. However,...
  7. P. 7

  8. P. 8

  9. P. 9

  10. P. 10

Text version

All VALLOUREC & MANNESMANN TUBES catalogues and technical brochures