42.008.126 Pressure Reducer
4Pages

{{requestButtons}}

Catalog excerpts

42.008.126 Pressure Reducer - 1

Product Information Pressure Reducer A. u. K. Müller Solenoid valves Control valves Special valves and systems A. u. K. Müller GmbH & Co. KG Dresdener Str. 162 D-40595 Düsseldorf/Germany e-mail: info@akmueller.de Internet: www.akmueller.de Characteristics Outlet pressure adjustable, factory presettable With snap-lock adjustment knob Balancing of inlet pressure Suitable for hot water up to 80°C Ambient temperature up to 70°C Reduced noise of flow Compact design Hydraulic functionality in accordance to EN 1567 Description The pressure regulator converts variable inlet pressures into a lower, constant outlet pressure. It can be used to protect equipment from high or inconsistent incoming medium pressure. This reduced and constant outlet pressure also enables a constant flow rate to be achieved independently of the incoming pressure. The orifice used to maintain this constant flow rate should be placed immediately after the pressure reducer. The pressure can easily be adjusted within the regulators specification range and is ideal for applications that require a constant flow rate or a specific timed volume delivery. Pressure reduction and flow rate regulation Protection of pressure caused damages of pipework downstream Pipework in home and industrial appliances Upstream to water inlet valves for appliances as vending and espresso machines, industrial appliances, steam ovens and others Long term performance capability by the use of high quality materials Available approvals KTW/W270 WRAS SVGW Others on request Typical flow rates at pressure p-in set to 8 bar, pressure p-out set to 1, 2, 3, 4, 5, or 6 bar. Flow determined by downstream located gradually opened ball valve. To ensure operation and long reliability of the pressure regulator it is recommended that a dirt strainer is fitted to the inlet. Check valves or solenoid valves can be placed downstream of the regulator. The hydraulic functionality according to DIN EN 1567 is confirmed by an accredited laboratory. Furthermore, WRAS and SVGW approved versions are available. © copyright A.u.K. Müller, subject to changes without prior notice

Open the catalog to page 1
42.008.126 Pressure Reducer - 2

Product Information Pressure Reducer Technical Data Type pressure reducer single chamber straight Fitting position any, direction of flow marked by arrow cold and heated potable water and physically and chemically similar media Inlet pressure Materials Valve body Spring and metallic parts stainless steel Pressure gauge connection Outlet pressure adjustment Release screw in middle of the cap Unlock the cap by pulling Set the desired output pressure by turning the cap Press back cap into the locking position Tighten again the screw in the cap middle slightly Upon delivery, the outlet pressure...

Open the catalog to page 2
42.008.126 Pressure Reducer - 3

Product Information Pressure Reducer Pressure gauge connection Other connection variants on request. © copyright A.u.K. Müller, subject to changes without prior notice

Open the catalog to page 3
42.008.126 Pressure Reducer - 4

Product Information Pressure Reducer Pressure gauge connection options Optional manometer NS: 50 mm Range: 0 - 10 bar Connection: G 1/4 radial on bottom ID: 006841 Please make sure that the pressure regulator is not bended during installation: Please support connections properly Please align connections properly Optional manometer Connection Bending torque NS: 50 mm Range: 0 - 10 bar Connection: G 1/4 center back © copyright A.u.K. Müller, subject to changes without prior notice

Open the catalog to page 4

All A. u. K. Müller catalogs and technical brochures

  1. Industry

    16 Pages

  2. Sanitary

    12 Pages

  3. Vending

    16 Pages