System, 5 Position, Battery Interconnect - Tyco Electronics Antennas - #1

02OctG7 Rev A

Produci

^VWfl^^_Specilicaiion

1.1. Content

Tliis specilicaiion covers performance, tests and quality requirements for the AMP" 5 position battery inlorconnoct system. System consists ot a ballory housing assembly and a printed circuit board mounted header assembly. Battery housing and header assembly are loaded with contacts tor resistive welding and thru hole soldering respectively.

1.2. Qualification

When tests are performed on s:;bjHi:l produci I ne, procedures spedlied in amp ma series speciticattons shall be usRd. All inspections shall be performed using applicable inspection plan and produci drawing.

2. APPLICABLE DOCUMENTS

The following documents form a part of this specification ¡0 Hie evieni specilied herein. Unless olherwi.se specified, lalesl edition ol Ibe doouineril applies. In 'lie event ol coulliel belween requirements of 111 Is specilicaiion and produci drawing, prod..;:! drawing shall lake precedence. In the event ol conllicl between requirements ol Ibis specilicaiion and referenced documents. Ih;.¹; spedi calkin shall lake precedence.

2.1. AMP Documents

a. 109 1 : General Requirements for l'osi Specifications

B. 109 Scries: Test Saccilicalions as indicated in Figure 1. (Comply wilh mil STD 202, mil

STD 134-4 and eia RS 364)

C. Corporale Bulletin 401 76: Cross rclcronce between amp Test specificalions and

Military or Commercial Documents

D. 501 305: Test Report

3.1. Design and Construction

Proci.;;:: s::<-:ll be el desia,;:, conslri/

n applicable produci drawing.

3.2. Materials

a. Contaci:

(1) Battery:

(2) Header:

B. Housing:

(1) Battery:

(2) Header:

a. Vol i age: 50 vdc

B. Current: See Figure 4 lor applicable current carrying capability

C. Temperature: -30to70^cC