Catalogs >
TQC Sheen BV >
CROSS CUT ADHESION TEST BASIC CUTTER

CROSS CUT ADHESION TEST BASIC CUTTER
3Pages

Catalog excerpts

CROSS CUT ADHESION TEST BASIC CUTTER - 1

Vision on quality www.tqc.eu TQC CROSS CUT ADHESION TEST - BASIC CUTTER SP1660, SP1661, SP1662, SP1663, SP1664 PRODUCT DESCRIPTION The TQC Cross Cut Adhesion Test (Basic Cutter) is used to test the adhesion of dry coats of paint on their substrate by means of a series of cuts through the coating. Two series of lines are cut at right angles to obtain a pattern of 25 / 100 squares. The ruled area is evaluated (by using a table chart) after a short treatment with a stiff brush, or adhesive tape (hard substrates). BUSINESS Protective Coatings, Corrosion Control, Coating Laboratories, Paint Production, Surface Finishing, Powder Coating, Decorative Coating, Building Maintenance STANDARDS ISO 2409, ASTM D3359 FEATURES • Self-adjusting knife-holder ensures equal pressure on the cutting knife • Ergonomically shaped handle • Easy to change cutting knife, no extra key needed • Wide range of knife sizes available for different coating thicknesses and substrates and according to different standards. SCOPE OF SUPPLY • CC2000 knife holder + grip • Knife of choice (see below schedule)

Open the catalog to page 1

CROSS CUT ADHESION TEST BASIC CUTTER - 2

Vision on quality www.tqc.eu yJ ACCESSORIES SP1702 - Spare knife ISO 1 mm SP1703 - Spare knife ISO 2 mm SP1704 - Spare knife ISO 3 mm SP1705 - Spare knife ASTM 1 mm SP1706 - Spare knife ASTM 1,5 mm SP3007 - Adhesion tape, single roll, adhesion to steel 4.3 N/cm SP3010 - Adhesion tape, set of 3 rolls, adhesion to steel 4.3 N/cm SP3020 - Adhesion tape, single roll, adhesion to steel 7.6 N/cm SP1710 - Nylon Brush for Cross Cut Adhesion Test SP1715 - Robust carrying case SP9700 - Lighted Magnifier 2.5x Make sure the surface to be tested is rigid and firm Make two cuts/scratch, perpendicular to...

Open the catalog to page 2

CROSS CUT ADHESION TEST BASIC CUTTER - 3

SPECIAL CARE • Though robust in design, this instrument is precision-machined. Never drop it or knock it over • Always clean the instrument after use. • Clean the instrument using a soft dry cloth. Never clean the instrument by any mechanical means such as a wire brush or abrasive paper. This may cause, just like the use of aggressive cleaning agents, permanent damage. SAFETY PRECAUTIONS • A knife is a sharp object. Be careful when using it. • Always use the cassette to store the knife DISCLAIMER The right of technical modifications is reserved. The information given in this sheet is not...

Open the catalog to page 3