6.4.Data Bits/Parity Bits/Stop Bits
P8n1 The first character, “8” corresponds to the number of data bits. (e.g. 7 or 8). Second character, “n” corresponds to the parity bit. (i.e. n- no parity, E- even parity, o- odd parity, 0- space, 1- mark) The last character, “1” corresponds to the number of stop bits. (e.g. 1 or 2) 8n1, 8n2, 7n2, 7E1, 7E2, 7o1, 7o2, 701, 702, 711,712 Note: There is no equivalent RS232/485 command.
6.5.Turnaround Delay
dt06 dt00, dt01, ...dtFE, dtFF The turnaround delay is unique to multipoint communications. It is the delay between receipt of an incoming command to transmission of the response. Each increase in the hex value corresponds to an increase in the delay time of approximately 8 ms. Note: Equivalent RS232/485 command. *{aa}T={dd}
S_EE EEW This command stores setting data to EPROM memory. Note: There is no equivalent RS232/485 command
6.7.Restore EEPROM r_EE
EER Note: There is no equivalent RS232/485 command IGE 300Page 16 of 21