Voltage Recorder/ Datalogger - Tecpel Co., Ltd. - #4

* Note: At recording interval of 1 sec: about 5 months / at rec. interval of more than 2 seconds: 9 months / at a recording interval of 0.02 seconds: about 13 days.

This device complies with Part 15 of the FCC Rules.

Operation is subject to following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE: This equipment has been tested and found to comply with the limits for a Class A Digital Device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver,

- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. ~ Consult the dealer or an experienced radio/TV technician for help.

Warning . щ₉ equipment has been verified to comply with the limits for a Class A personal digital device, pursuant to Subpart В of Part 15 of FCC Rules. Only peripherals (computer input/output devices, terminals, printers, etc.) certified or verified to comply with the Class A or В limits may be attached to this equipment Operation with non-certified or non-verified personal computer and/or peripherals is likely to result in interference to radio and TV reception. The connection of a non-shielded equipment interface cable to this equipment will invalidate the FCC Certification of this device and may cause interference levels which exceed the limits established by the FCC for this equipment

You are cautioned that changes or modifications not expressly approved by party responsible for compliance could void your authority to operate the equipment

On computers where the Hyper-Threading function is activated, problems have been found to occur when downloading data with a USB-Serial Cable conversion adaptor. There are two solutions to this problem. The first is to turn off the Hyper-Threading function (usually done in the BIOS settings). The second possible solution is to download data on a computer that has a serial port

Contact your local authorized T&D sales representative about USB-Serial conversion adaptors.

Voltage Data Logger VR-71

Voltage Recorder for Windows

AAA Alkaline Batteries x2 (LR03)

(VR-7101)

RS-232C (D-sub 9Pin)

oe

fflfl......DG

I System Setup

Sensors

Data Logger (VR-71)

Software

Input Cable

Printer

_^-nn|— ...

Connect Communication Cable

D-sub 9Pin

CE

AAA Batteries CE

D-sub 9Pin (RS-232C)

JO