table.main {} tr.row {} td.cell {} div.block {} div.paragraph {} .font0 { font:7.00pt "Verdana", sans-serif; } .font1 { font:9.00pt "Verdana", sans-serif; } .font2 { font:11.00pt "Verdana", sans-serif; } .font3 { font:12.00pt "Verdana", sans-serif; } .font4 { font:14.00pt "Verdana", sans-serif; } .font5 { font:26.00pt "Verdana", sans-serif; } .font6 { font:31.00pt "Verdana", sans-serif; } ProductInformation lanlecEZ PipeTE eatment of Jacket Pipes TECHNICAL DATA PipeTEC Corona Treatment of Jacket Pipes Features: The PipeTEC is designed for treatment of the inside surface of jacket pipes for optimised adhesion of PUR foam which is needed for insulation of the pipe core. The PipeTEC must be fully integrated into an extrusion line and ensures a very high level of surface treatment of the entire inside surface. High power treatment Easy to operate The purpose of surface treatment of polymer-based materials is to increase surface wettability through electrical discharge. The low surface energy of polymer-based substrates - like PE and PP pipes, often lead to poor adhesion properties. It is commonly known that an untreated inside pipe surface will result in "air pockets" when foaming, which will lead to condensation and eventually result in pipe failure when in use. The Tantec PipeTEC is specially designed for optimising the adhesion properties of the inside surface of jacket pipes prior to foaming with PUR foam. Tantec offers two different types of inside electrode systems depending on pipe size and tolerances. The stainless steel shaped blade electrodes offer the ultimate treatment of the inside surface, but for larger pipes with large tolerances the stainless steel brush electrodes is a better choice. Magnetic holding systems for keeping the inside electrode system in place are offered in combination with stainless steel shaped electrodes. For dimensions up to OD 630 mm. Brush electrodes and larger shaped electrodes must be kept in place using a metal wire from the extrusion tool or something similar. The PipeTEC is normally integrated right before the saw. Fully integrated into extrusion line Tantec A/S . Industrivej 6 . DK-6640 Lunderskov . T. +45 7558 5822 . [email protected] Tantec GmbH . Monsheimer Str. 20 . D-71299 Wimsheim . T+49 7044 950012 . [email protected] Tantec EST Inc . 160 N. Brandon Drive . IL-60139 Glendale Heights . T +1 630 351 1320 . [email protected] www.tantec.com

table.main {} tr.row {} td.cell {} div.block {} div.paragraph {} .font0 { font:19.00pt "Georgia", serif; } .font1 { font:7.00pt "Verdana", sans-serif; } .font2 { font:9.00pt "Verdana", sans-serif; } .font3 { font:12.00pt "Verdana", sans-serif; } .font4 { font:14.00pt "Verdana", sans-serif; } .font5 { font:17.00pt "Verdana", sans-serif; } .font6 { font:31.00pt "Verdana", sans-serif; } adhsif COaMMbsion TechnicalData Plasma & Corona Treaters glu鎯ng bonding Features: Dedicated lectrodes for each single pipe dimension ensures optimum treatment results. Just install the correct electrode dimension....