High-blow nozzle - Taketsuna - #1

Characteristic

PH1

Measure accuracy is high because this is manufactured aluminum extrusion process of enamel structure. And, mass production is highbecause section is a rational form. So, this is the High-blow nozzle that demonstrates highly efficient and cheap.

PH2

Slit width is able to be adjusted easily. Corrosion resistance is very good because the material of the chamber are used 6063(JIS). And, this is very beautiful finish because anodized aluminum processing is being performed to the surface. Hard anodized aluminum processing is being performed to the slit (Material : aluminum) too.

PH3

This is able to correspond to high temperature gas (Max. 250° C) and steam (Resisting pressure is less than 2kgf/cm²) by simple enamel structure. Pressure loss was improved more substantially in comparison with the existing model by simple structure. As a result, Sound of wind was reduced and electric power consumption volume of the occurrence device of the supply air resource is improved substantially

too. _

• [jOder (Liquid specification) | In the case that liquid is used, anodized aluminum processing is performed to the inside. And, slit width becomes fixation and not able to adjust because chamber and slit are glued.

PH4

Air that discharge from the slit without the joint demonstrate highly efficient of completely uniform with the whole slit. (Accuracyrating of the disorder of the air speed of the right and left is within ±3%. )

PH5

(A) Involvement of air from surroundings of air that is discharged at high speed decreases by ideal slit angle Therefore, attainment distance of the air that was discharged extended.

Model 40AL and 50AL is possible to changes to (A) the right discharge and (C) left discharged irection of the air that was discharged from the slit while the chamber is fixed by adjusting the slit.

PH6

This is able to correspond even for the nozzle for suction. Photograph is the one that combined Model High-blow nozzle 50AL (For suction) and Model High-blow nozzle 25AL (For discharge) as the reference example (order).

Fixation method

PH7 All typse of slit length that is more than 401mm is equiped the metal foot-fixers at standard (Material SUS304).

• Type of slit length that is less than 400mm fixes the screw side and the other side is free.