Characteristic

Material is stainless steel. (SUS304 Finish of the surface is 2B) This is verylow pressure loss and the high air-speed is obtained because the inside is simple rectification structure. And, this is the energy conservation type because the electricity consumption quantity of the supply air resource professional generator can be reduced substantially. (Even electrolysis processing grinding are informed with the opution.) Air that was discharged from the seamlessness slit demonstrates completelyuniform highly efficient at the whole slit. Accuracy rating of the disorder ofthe air-speed of the right and left is within plus minus 5% if it is the use insidea standard (except for the both ends department 25mm of the slit). Slit width can be adjusted easily. Problem can be solved on site by adjustingslit width in the case that disorder happened to discharge air-speed.Hexagon stick spanner for the slit width adjustment is equipped standard. Attention) A little air may leak from both sides of the slits because the slit width adjustment possibility type.Attention) Please confirm the operation manual without fail about the adjustment method of slit width. Going straight performance and attainment distance of discharge air went up substantially in comparison with the conventional blow supplier of nozzle because the only a few surroundings air are involved.Fixation metal professional fittings are equipped to all the types. (Material SUS) Side attachment, upper attachment, and lower attachment can be selected by usingthe fixation metal fittings. And, the discharge angle can be adjusted easily. Attention) Type of the fixation metal fittings differs when the slit length is more than 1001mm. Please refer to the figure of each size.Attention) Fixation metal fittings is S-type when the slit length is less than1000mm. Fixation metal fittings is L-type when the slit length isAttention) The type and measure of the fixation metal fittings differsirrespective of slit length at the time of the change type of the air more than 1001mm.supply inlet (order).These are the low pressure type branching pipes that had an ideal taper angle.These can produce cheaply by the instructions of the hope inlet bore, outletbore, and type.

Industry first Patent and designs

(Japan, Taiwan, China, and Korea) Slit adjustment screw

Perfect Simple Highly efficient Light Option

Within plus minus 5% Slit width Side attachment Lower attachment

(Material SUS)

3-Branching pipe4-Branching pipe