Text version of the page

model

Converting, coating, and printing processes ? Dry particle transport systems

Electrostatic Fieldmeters - 52552 Features: The only full-time, plant-wide automaticdefense against undetected static buildup

? “Static-free” environments ? Explosive atmospheres - Safely monitorspotentially hazardous sites to detect charge buildup. Model 1036 Sensors are Factory Mutual Research approved: Class I, Division 1, Groups C and D hazardous locations.

• Intrinsically safe sensor operation (with optional barriers) in explosive atmospheres

Monroe Static Monitor/Alarm System model 177A,an enhanced version of the 177, is the only intrinsically safe system that continuously monitors the critical points in your facility to detect and warn of electro- static charge buildup before it becomes a problem.In a typical scenario - as static levels in yourapplication surpass a preset value, beyond which there may be a danger to personnel or possible disruption or destruction to the process or product, an initial warning is triggered and the process is allowed to continue. If the problem is rectified, the “warning” returns to a “normal” state. If the condition persists and the static level exceeds a second more crucial value, an alarm is activated terminating the process until corrective action is taken and the system is reset.Accurate, versatile and dependable, unattendedoperation makes the 177A ideal for applications such as:?

. ?4 channel Static Monitor detects staticlevels in as many as four locations upto 1000 feet away?Accurate and drift-free measurementincluding ionized envorionments?Provides analog outputs andcontrol via RS232/485 and front panel?Control and data acquisition,configuration via RS232/485 usingMODBUS interface format?Built in, fully configurable dual levelalarms programmable via front panel,PCor PLC?Cascade up to 32 units via RS485providing 128 sensor locations?Simple Windows

®

GUI interface for setup and control?PLC compatible using MODBUSprotocol?Password Security?“Fail safe” relay configuration?“Bad Input” protection or console failureindication?Founded on proven MonroeElectronics Non-Contact ElectrostaticFieldmeter technology Simple to install and use

The 177A is as easy to install and use as it iseffective. In a short time you can:1.Mount sensors at all static-critical locations.2.Mount the 177A console in your rack enclosure.(Monitoring more than four location requiresadditional consoles.)3.Connect leads between sensors and console andRS485/232 and Alarm contact.4.Install software and configure your system.5.Turn console power on and zero each channel tobe used.6.Begin reliable, continuous, drift-free, multi-point static measurements.

Static Clean International • 15 Adams St., Burlington, MA 01803 Tel: 781-229-7799 Fax: 781-229-4555 • www.staticclean.com

11/05