Atomizers - Sonics - #1

Text version of the page

SONICS & MATERIALS, INC., 53 CHURCH HILL ROAD, NEWTOWN, CT 06470-1614 USA 1-800-745-1105 ULTRASONIC ATOMIZERS Low and Medium Atomization Rate – 20 kHz and 40 kHz GENERAL DESCRIPTION Unlike conventional atomizing nozzles that rely on pressure and high-velocity motion to shear a fluid into small drops, the ultrasonic atomizer uses only low ultrasonic vibrational energy for atomization. The liquid can be dispensed to the atomizing probe (nozzle) by either gravity or a small low-pressure metering pump, and atomize continuously or intermittently. The rate at which the liquid is atomized depends, within limits, solely on the volume that is being delivered onto the atomizing surface, and the frequency. Typically, the higher the frequency, the lower the processing capability. The amount of material atomized can be as little as 2 ìl/sec. Because the droplets typically drift downward at low velocity under the influence of gravity, the probe should be mounted with the tip facing downward, and air turbulence kept to a minimum. A wide variety of coatings, chemicals, lubricants, and particulate suspensions can readily be atomized. However, factors such as viscosity, miscibility, and solid content deserve consideration. For optimum atomization, the viscosity should be under 50 cps and the solid concentration kept below 30%. Because the atomization process depends on setting a liquid film into motion, typically the higher the viscosity – the lower the flow rate, and the more difficult the application. The atomization of liquids containing long-chained polymer molecules is problematic, even in diluted form, due to the highly cohesive nature of the material. In many cases, mixtures with particulates can be atomized, because the solids are simply carried along in the drops. The low transport velocity of the liquid through the probe permits even abrasive slurries to be processed with negligible erosion of the passageway. Compared with conventional pressurized nozzles, the feed channel running through the probe and exit orifice are relatively large, and practically uncloggable. Drop size is primarily a function of frequency, and the higher the frequency, the smaller the drop diameter. The median drop size at 20 kHz is 100 microns, and 60 microns at 40 kHz. VC 5020 AT / VC 5040 AT TYPICAL APPLICATIONS  Coating non-woven fabric, paper, etc.  Laboratory spray drying  Injecting moisture into a gas stream  Applying minute amount of oil, fragrance or flavor onto a product  Injecting small volume of reagents into a reactor  From microliters to liters – continuous or intermittent  Dispenses material with virtually no overspray  Pressureless atomization – low velocity mist  Low cost atomizing probe replacement  Minimal atmospheric contamination  Virtually uncloggable