1

Product information

2

Recommendations fig .10.Mount the second industrial seal accordingto steps 7 to 9.11.If the bearing is not immediately re-used, preserve the bearing sur- faces with oil and make sure that the bearing is well packed.

3

Product data Page ............. 3 ( âž” fig ) andpushing it out of the groove.2.Remove the second retaining ringas above.3.Swivel out the inner ring, so thatthe seals are pushed out by the rollers.4.The bearing, seals and retainingrings can now be washed5.Inspect the parts for further usability. 6.Regrease the bearing with innerring swivelled out.7.Align the bearing and put it on aclean surface for remounting the seals.8.Insert the seal as far as possibleinto its groove in the outer ring.Hold down the already insertedpart of the seal with one hand, and press in the remainder, stepwise with the thumb of the other hand Maintenance Page ............. 32

Maintenance

9.Mount the retaining ring by insert-ing the rectangular end first. Holding this part down, press in the remainder stepwise with a tool, until the whole retaining ring proper- lycontacts the seal as shown in ( âž” fig ). The seals can be removed from the bearing so that the bearing can be inspected, washed and regreased, after which the seals can be reinserted and secured. To avoid damage to the seals, this work has to be done with care, using suitable, well rounded tools with no sharp edges.1.Remove the retaining ring by insert-inga tool under the recessed end of the retaining ring The seals of SKF spherical roller bear-ings with a bore diameter of 110 mm and above are secured by retaining rings inserted in the outer ring
4 ( âž” fig ) .
4

2

5 6 Removing a retaining ringInserting the seal in the outer ring Fig 5 Fig 6 31