Special industrial separator design allows the puller to be easily inserted between the bearing and the shoulder on the shaft, even in the tightest spaces The firm grip behind the bearing's inner ring reduces the force required to dismount the bearing High load rating oflOO kN (11.2 ton US) make the TMBS 100E and TMBS 150E suitable for use in many applications TMBS 100E and TMBS 150E offer complete hydraulic puller kits, allowing effortless generation of force The extension rods of the TMBS 100E and TMBS 150E allow easy and quick adaptation to required pulling length Maximum reach of 825 mm (32.5 in) and maximum shaft diameter of 150 mm (6 in) allow the TMBS E series to be used in many applications The hydraulic spindle is equipped with a safety valve, which limits the applied force to 100 kN (11.2 ton US), minimising the risk of puller overload The spring-loaded centre point of the hydraulic spindle allows easy centring of the puller on the shaft without damaging it Long stroke of hydraulic spindle, 80 mm (3.1 in), facilitates dismounting in one operation Pumping mechanism used for force generation is effortless and more efficient than turning mechanism Extension pieces ofthe hydraulic spindle allow quick adaptation to pulling length |