floor stripping machine - 22 Pages

2.4 Restriction of use The Turbo Stripper is exclusively for removing bonded floor covering in dry environments. It should not be used for any other purpose. Sinclair Equipment Company cannot be held responsible for any damage or loss caused by incorrect use. 2.5 Genuine Spare Parts Spare parts and accessories are manufactured uniquely for the Turbo Stripper. It must be emphasized that parts obtained from unauthorized sources must not be used. Sinclair Equipment Company cannot be held responsible for the performance of or any damage arising from the use of machines in which genuine spare parts have not been used. This is particularly important with replacement blades. 2.6 Low-voltage Protection The Turbo Stripper is equipped with a low-voltage protection switch. The power supply breaks if current fluctuation or main power failures occur, thus preventing serious accidents. Due to the restart protection, the machine will not restart after a power failure, even if the operation switch has not been switched off. For using the protective cut-out switch see item 5.0. >
5 size="-1">

floor stripping machine
  1. P. 1

    TURBO STRIPPER II Operating Manual Read before use and keep safe >Rev A Starting With Turbo II Ser# 193-07 06/21/07 (800) 624-2408 (530) 626-9386 Fax...
  2. P. 2

    Table of Contents 1.0 Technical Data Page 3 2.0 Safety Page 3 3.0 Assembly & Handle Adjustment Page 6 4.0 Maintenance Page 7 5.0 Use Page 8 6.0 Information...
  3. P. 3

    1.0 Technical data/technical description Stripper, 2 rigid blades, safety goggles and tool kit. Power supply 110-120V AC Power consumption 2200W Number...
  4. P. 4

    Transport Always remove the blade before transporting the machine. Disconnect the power supply and the plug of the clutch before removing the handle. Otherwise...
  5. P. 5

  6. P. 6

    3.0 Assembly of Machine & Handle Insert handle into Turbo II base as shown in diagram. Tighten wing bolts in handle. Note that bolts are spring loaded...
  7. P. 7

    4.0 Maintenance CAUTION!! Press maximum of 3 times with the grease gun. Never press too much grease into the machine. Otherwise the mechanism will be blocked....
  8. P. 8

    Changing the blade Disconnect the power supply and put on the blade protection before changing the blade.Use work gloves for your own safety. - release...
  9. P. 9

    The Turbo Stripper is equipped with a Power -on indicator lamp (1) and an operating Switch located at the top of the handle. The switch has a restart protection...
  10. P. 10

    Assembly of support for additional weight (accessory) The weight of the Turbo Stripper is expandable by 1 up to 3 additional weights (each weight is 66...
  11. P. 20

Text version

All Sinclair Equipment Company catalogues and technical brochures