Catalog excerpts
Process meters SWE-73-L E low-cost loop-powered meter in a small case measurement input 4-20 mA optional alarm output available signal peak value detection all parameters are freely programmable from the remote control SWE-73-L is a simple and low cost digital indicator with a single 4-20 mA current input, which powers this device at the same time. Measurement input is equipped with safety circuits, saving internal electronics against overload. Device has possibilities of recalculating measured current according to few predefined transfer functions (linear, square, square root) or fully definable user characteristic (max. 20 points). Result is displayed on 4-digit red LED display, the range of the result is: -999 to 9999, with definable decimal point position. The device can be equipped with optional SPDT relay. Due to users safety requirements this output can drive a bulb lamp as well as sound signaling device but must not be used for controlling purposes. Configuration of the device can be done using IR remote controller (when input current is higher than 10 mA, what is signalised by additional LED). TECHNICAL DATA SIMEX Ltd., Wielopole 11, 80-556 Gdansk, Poland, tel. (+48) 58 762-07-77, fax 58 762-07-70, www.simex.pl
Open the catalog to page 1Process meters QsimEX DIMENSIONS Panel cut-out dimensions units: 0 : no unit on display options: 00 : no options 01 : IP 65 frame 08 : operating temp. -20°C f +50°C 0P : IP 65 frame + operating temp. -20°C f +50°C 0M : signalization output 0N : IP 65 frame + signalization output 0Q : signalization output + operating temp. -20°C f +50°C 0V : IP 65 frame + signalization output + operating temp. -20°C f +50°C SIMEX Ltd., Wielopole 11, 80-556 Gdansk, Poland, tel. (+48) 58 762-07-77, fax 58 762-07-70, www.simex.pl
Open the catalog to page 2Meters accessories MOUNTING PLATES SMP-147/73 to mount 72 x 36 mm size unit in place of 144 x 72 mm cut-out REMOTE CONTROLLER SIR-15 InfraRed remote controllers may be used as external programming keyboard for all SIMEX devices equipped with IR receivers and remote programming functions. Pressing of any local IR controller key, causes transmission of it's code to the device. Functions of particular keys depend on devices features. Power supply voltage: Operation range: 6V DC - 4 alkaline batteries type LR44 from 0,5 to 5 m (depend on programmed device features) SOFTWARE S-Config 2 is used...
Open the catalog to page 3All SIMEX Sp. z o.o. catalogs and technical brochures
-
Temperature sensors catalogue
96 Pages
-
STH-42
2 Pages
-
SPP-638
3 Pages
-
SLC_30_46_47
2 Pages
-
SLN-44
2 Pages
-
SLE-42
2 Pages
-
SWZ-W610
3 Pages
-
SPP-N118
3 Pages
-
SPP-94
3 Pages
-
SPI-638
3 Pages
-
SPI-N118
3 Pages
-
SPI-94
3 Pages
-
STI-638
3 Pages
-
STI-N118
3 Pages
-
STI-94
3 Pages
-
STI-73
3 Pages
-
SLN-94
3 Pages
-
SLK-94T
3 Pages
-
SLIK-638
3 Pages
-
SLIK-N118_eng.pdf
3 Pages
-
SLB-94
3 Pages
-
SLIK-94
3 Pages
-
SLIK-73
3 Pages
-
SLE-73
3 Pages
-
SLC-457
3 Pages
-
SLC-94
3 Pages
-
MultiCon
19 Pages
-
SCK-11
1 Pages
-
SimCorder Soft Overview
7 Pages
-
Galvanic Isolators brochure
4 Pages
-
Digital indicator SWS-147
3 Pages
Archived catalogs
-
MultiCon Overview
19 Pages
-
SWS-99
1 Pages
-
Product Overview BROGOEN
32 Pages
-
MultiCon overview BRCMCEN
19 Pages
-
Product Overview
33 Pages
-
BROGOEN_v1.15.071
28 Pages
-
MultiCon brochure
13 Pages
-
SIMEX Product Overview 2014
28 Pages
-
MultiCon brochure
11 Pages
-
SIMEX Catalogue
78 Pages