Wire-actuated encoder - SIKO - #7

/ 60


catalogue search
P. 01
P. 02
P. 03
P. 04
P. 05
P. 06
P. 07
P. 08
P. 09
P. 10
P. 11
P. 12
P. 13
P. 14
P. 15
P. 16
P. 17
P. 18
P. 19
P. 20
P. 21
P. 22
P. 23
P. 24
P. 25
P. 26
P. 27
P. 28
P. 29
P. 30
P. 31
P. 32
P. 33
P. 34
P. 35
P. 36
P. 37
P. 38
P. 39
P. 40
P. 41
P. 42
P. 43
P. 44
P. 45
P. 46
P. 47
P. 48
P. 49
P. 50


See other catalogues for SIKO

Text version of the page
7 Mounting note When attaching the wire it should be pulled out straight in line with the wire outlet. initial position final posotion~5mmmeasuring rangemax. extension length Recommendation: A 5 mm wire extension is recommended before the measurement starting point. This prevents the wire snapping back to the stop on rewinding. Mounting example Guide rollers are used wherever the wire-actuated encoder can-not be installed in line with the extension direction of the wire. Several rollers can be used to redirect the wire without influenc- ing the measurement result. An opening slightly larger than the diameter of the wire is suf-ficient as a point of access at measurement sites which are hard to reach. A protective cover is recommended for use in soiled environments. Note: Mechanical stress shortens the lifespan of the wire.A wire extension piece can be used for applications where the distance between the wire-actuated encoder and the measure- ment range is greater than the wire’s maximum extension length. This does not extend the actual measurement range, however (see above: mounting note). This simple method is useful for measurements in areas where a suciently large distance is required between the wire-actuated encoder and the measured object due to high temperatures, harsh environ- ments, measurement in liquid media, areas which are dicult to access, etc.Detailed information on guide rollers or wire extension pieces can be found on the product page in the accessories section. 3 . 1 3 . 23
guide pulleywire-actuated encoder wire extensionmeasuring range . 33 . 4 3 . 5 3 . 6 3 . 7
Customer-specific encoders All rotary encoders with the following specifications can be installed on the SG60, SG120 and SGL wire-actuators (see dia-gram): 58 mm servo/synchro flange min 14max. 1933 h7 â–  ø58 ø50 â–  6, 8 and 10 mm solid shaft* g6 ø6 â–  Maximum starting and operating torques 3 Ncm* *depends on device: see product pages! 3 LinearLine | 3.1 Wire-Actuated Encoders www.siko.de

pageCatalog pdf di En 2012-02-07-13