Appendix Mounting examples, Output signals Torque support

The hollow shaft design of DriveLine actua-tors AG01, AG02 and AG03 makes for very simple mounting. A clamp ring on the de- vice mounting side provides secure connec-tion to the machine shaft. The torque bracing to the machine frame is by means of a pin [1]. [2] [3] Alternatively, a mounting bracket [2] can be used. This type of securing enables use of an elastomere bushing [3] which provides a low-tension connection from the actuator to the machine shaft. Advantage: The distortion forces on the bearing are reduced..

26

[1]

Mounting variants

The cleverly designed form opens up a host of installation variations. The tapered construction in the area of the hollow shaft makes small center-to-center distances of as little as 37 mm achievable.

37 3737

37 35 37

Output signals incremental

AG01*, AG02, AG03* AG12

A /A B /B 0 I

A /A B /B

* Note: The status of the signals A and B regarding the reference signal 0/I is not defined and may deviate from this drawing.