Catalogues - siemens-measuring-instruments-for-pressure

Catalogue Siemens - Measuring instruments for pressure

www.siemens.com/processautomation

Page

/ 222

Make a request

SIEMENS Process Instrumentation - 14636, 2111, 2625, 2145

/ 222

See other catalogues for SIEMENS Process Instrumentation

Text version of the page

SITRANS P measuring instruments for pressure

Transmitters for gage and absolute pressure

SITRANS P300

HART communication

HART communication Protocol

Software for computer

Communication FOUNDATION Fieldbus

Function blocks

3 function blocks analog input, 1 function block PID

230 ... 1100 Q HART Version 5.x SIMATIC PDM

Analog input

Adaptation to customer-specif- Yes, linearly rising or falling char-

ic process variables

acteristic

PROFIBUS PA communication

Simultaneous communication with master class 2 (max.)

The address can be set using

Electrical damping T₆₃ , adjust- 0 ... 100 s able

Simulation function

Output/input (can be locked within the device with a bridge)

Can be parameterized (last good value, substitute value, incorrect value)

Yes, one upper and lower warning limit and one alarm limit respectively

Yes

Configuration tool or local operation (standard setting address 126)

Failure mode

Cyclic data usage

• Output byte

• Input byte

Internal preprocessing Device profile

Function blocks

• Analog input

5 (one measuring value) or 10 (two measuring values)

0, 1, or 2 (register operating mode and reset function for metering)

Limit monitoring

- Square-rooted characteristic for flow measurement

• PID

• Physical block Transducer blocks

Standard FF function block

1 Resource block

1 transducer block Pressure with calibration, 1 transducer block

LCD

PROFIBUS PA Profile for Process control Devices Version 3.0, Class B

• Industrial pressure transducer block

- Can be calibrated by applying two pressures

- Monitoring of sensor limits

Adaptation to customer-specific process variables

Yes, linearly rising or falling characteristic

Yes

Electrical damping T₆₃ , adjust- 0 ... 100 s able

Yes

Constant value or over parameter-

- Simulation function

- Failure mode

- Limit monitoring

• Register (totalizer)

- Failure mode

- Limit monitoring

• Physical block Transducer blocks

• Pressure transducer block

- Can be calibrated by applying two pressures

- Monitoring of sensor limits

- Specification of a container characteristic with

- Square-rooted characteristic for flow measurement

- Gradual volume suppression and implementation point of square-root extraction

- Simulation function for measured pressure value and sensor temperature

Input /Output

Can be parameterized (last good value, substitute value, incorrect value)

Yes, one upper and lower warning limit and one alarm limit respectively

Can be reset, preset, optional direction of counting, simulation function of register output

Can be parameterized (summation with last good value, continuous summation, summation with incorrect value)

One upper and lower warning limit and one alarm limit respectively

Simulation function: Measured

pressure value, sensor temper- izable ramp function ature and electronics temperature

Yes Yes

Max. 30 nodes

Yes

Parameterizable

Constant value or over parameter-izable ramp function

2/34

Siemens FI 01 • 2008