| | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | |
| | | |
| | | © Siemens AG 2007 | | |
| | | |
| | | SITRANS P measuring instruments for pressure | | |
| | | |
| | | • Upper and lower current saturation limit • Electrical damping The other two keys are used to set the values in the individual operating modes. The green LED signals that the measured pressure lies within the set limits. The red LED industrial lights up when the measured pressure lies outside the set limits and when there is an error. | | |
| | | Rated conditions Ambient conditions • Ambient temperature • Storage temperature Medium conditions • Process temperature Degree of protection Electromagnetic compatibility • Emitted interference and interference immunity | | |
| | | -25 ... +85 °C (-13 ... +185 °F) -40 ... +85 °C (-40 ... +185 °F) -30 ... +100 °C (-22 ... +212 °F) IP65 to EN 60529 | | |
| | | |
| | | To EN 61326/A1 appendix A (1998) | | |
| | | |
| | | Display Decimal point Limit values Limit violation display | | |
| | | LCD, max. 5 digits, digit height 9 mm Freely parameterizable Freely parameterizable Red LED and message on LCD (t symbol /4 symbol in case of limit violation in upward / downward direction) With 3 keys mA or % or physical variable (default setting: bar) Other dimensions: mbar, kPa, MPa, mmH20, mH20, psi, inH20, mmHg, kg/cm2, torr, atm Between 0.1 and 100 s (increment: 0.1 s) freely parame-terizable | | |
| | | |
| | | Measuring principle | | | | |
| | | |
| | | Input Measured variable Measured range 0 ... 2 bar (0 ... 29 psi) 0 ... 10 bar (0 ... 145 psi) 0 ... 50 bar (0 ... 725 psi) 0 ... 200 bar (0 ... 2900 psi) 0 ... 400 bar (0 ... 5800 psi) Measured range 0 ... 2 bar (0 ... 29 psi) 0 ... 10 bar (0 ... 145 psi) 0 ... 50 bar (0 ... 725 psi) 0 ... 200 bar (0 ... 2900 psi) 0 ... 400 bar (0 ... 5800 psi) Range adjustment (turndown) | | |
| | | Gage and absolute pressure Resolution 0.6 mbar (0.008 psi) 3 mbar (0.044 psi) 15 mbar (0.218 psi) 60 mbar (0.9 psi) 120 mbar (1.8 psi) Overload limit 5 bar (72.5 psi) 25 bar (363 psi) 120 bar (1740 psi) 500 bar (7250 psi) 600 bar (8700 psi) 5:1 | | |
| | | |
| | | Parameterization Units | | |
| | | |
| | | Damping | | |
| | | |
| | | |
| | | Design Weight | | |
| | | «0.6 kg (=1.32 lb) Using 2-pole plug connector with M16x1.5-Cable inlet to EN 175301-803A, plastic • Male thread G1/B and female thread G1/8B • G1/B to EN 837-1 • Female thread: /-14 NPT 1 Radial (type A), can be swiveled by max. ±120° (a) Axial (type B), can be swiveled by max. ±360° | | |
| | | |
| | | |
| | | Output Output signal Lower current limit Upper current limit Output protected against Max. load Voltage measurement | | |
| | | |
| | | 4 ... 20 mA min. 3.6 mA max. 23 mA Reversed polarity, overvoltage and short-circuiting R B = (UH-12V) / 0.023 A Linear rising | | |
| | | Version of housing/process connection | | |
| | | |
| | | |
| | | Material Non-wetted parts materials • Field housing • Cover Wetted parts materials • Measuring cell • Gasket • Process connection | | |
| | | |
| | | Measuring accuracy Error in measurement (including non-linearity, hysteresis and repeatability, at 25 °C (77 °F)) Adjustment time Long-term drift Influence of ambient temperature Vibration influence Power supply effect | | To EN 60770-1 < 0.25% of full-scale value (typical), max. 0.5% | | |
| | | 0 80 mm (3.15 inch), stainless steel mat. No. 1.4016 Stainless steel, mat. No. 1.4016 with glass | | |
| | | |
| | | < 100 ms 0.25% of full scale value/year < ±0.25%/10 K (< ±0.25%/10 K) of full-scale value 0.05%/g to 500 Hz in all directions (to IEC 68-2-64) < ±0.01%/V of full-scale value | | |
| | | |
| | | Al2O3 Viton Stainless steel, mat. No. 1.4571/316Ti | | |
| | | |
| | | |
| | | |
| | | |
| | | Power supply Terminal voltage on pressure transmitter (UH) | | |
| | | 12 ... 30 VDC | | |
| | | |
| | | |
| | | Certificate and approvals Classification according to pressure equipment directive 97/23/EC | | |
| | | For gases of fluid group 1 and liquids of fluid 1; complies with requirements of article 3, paragraph 3 (sound engineering practice) | | |
| | | |
| | | |
| | | 2/12 | | |
| | | Siemens FI 01 • 2008 | | |
| | | |
| | | |
| | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | |