Catalogs >
Shanghai Zhaohui Pressure Apparatus Co.,Ltd.(ZHYQ) >
ZHYQ Melt pressure transducer PT124G-128 plastic extruder

ZHYQ Melt pressure transducer PT124G-128 plastic extruder
4Pages

Catalog excerpts

ZHYQ Melt pressure transducer PT124G-128 plastic extruder - 1

Melt Pressure Transducer Model: PT124G-128 ( space restricted) Description PT124G-128 Series melt pressure transducer is ideal for space restricted areas applications required, where mounting space is limited. It also has a free-spinning jam nut that simplifies installation. The series comes equipped with six or eight pin bendix connector. It can be interchangeable with the similar world standard products. It is suitable to measure and control the melt pressure in chemical fiber equipment, rubber and plastic machine and so on. Application  Chemical fiber& spinning Equipment  Polyester equipment  Other pressure measurement and control Feature  High-standard quality  Accuracy better than ± 0.5%  Stainless steel wetted parts  Internal 80% Shunt Calibration  Good stability and repeatability  Exposed, bendable capillary Dimension ZHYQ Sensor & Cont

Open the catalog to page 1

ZHYQ Melt pressure transducer PT124G-128 plastic extruder - 2

Ordering Guide Shanghai Zhaohui Pressure Apparatus Co., Ltd Page 2 of 4 5-6F No.8 Building No.115 ,Lane 1276 Nanle Road Songjiang District Shanghai 201600 China Tel:+86-21-51691919 67755189 Fax:+86-21-67755185 E-mail: info@zhyqsensor.com A cnsi ZHYQ Sensor & Control

Open the catalog to page 2

ZHYQ Melt pressure transducer PT124G-128 plastic extruder - 3

Melt pressure transducer/transmitter Operating instruction Attention for installation 1, Installation Do not remove protective cap until ready to install. Prior to initial installation, verify correct machining of mounting hole. Install with aluminum gasket. The electronics housing should be secured, with the enclosed mounting bracket. 2, Remove Make sure that there is no remained metal or plastic; remove all of the transducers from the equipment before you clean the extruder. You can remove the transducer only when the polymer is molten. And clean the diaphragm of the transducer with soft...

Open the catalog to page 3

ZHYQ Melt pressure transducer PT124G-128 plastic extruder - 4

Wiring diagram Shanghai Zhaohui Pressure Apparatus Co., Ltd 5-6F No.8 Building No.115 ,Lane 1276 Nanle Road Songjiang District Shanghai 201600 China Tel:+86-21-51691919 67755189 Fax:+86-21-67755185 E-mail: info@zhyqsensor.com www.zhyqsensor.com C€ ZHYQ sensor & control

Open the catalog to page 4