ATEX certificate for LEEG pressure transmitter
3Pages

{{requestButtons}}

Catalog excerpts

ATEX certificate for LEEG pressure transmitter - 1

TypeExaminationCertificate CML19ATEX1078X Issue 0 Equipment intended for use in Potentially Explosive Atmospheres Directive 2014/34/EU Equipment DMP305X-**T-*****-**-*C-*-* Gauge/Differential Pressure Transmitter Manufacturer Shanghai LEEG Instruments Co., Ltd. Address No.100, Duhui Road, Minhang District, Shanghai, 201109, China The equipment is specified in the description of this certificate and the documents to which it refers. CML B.V. , Chamber of Commerce No 6738671, Hoogoorddreef 15, Amsterdam, 1101 BA, The Netherlands, Notified Body Number 2776, in accordance with Article 17 of Directive 2014/34/EU of the European Parliament and of the Council, dated 26 February 2014, certifies that this equipment has been found to comply with the Essential Health and Safety Requirements relating to the design and construction of equipment intended for use in potentially explosive atmospheres given in Annex II to the Directive. The examination and test results are recorded in the confidential reports listed in Section 12. If an ‘X’ suffix appears after the certificate number, it indicates that the equipment is subject to conditions of safe use (affecting correct installation or safe use). These are specified in Section 14. This EU Type Examination certificate relates only to the design and construction of the specified equipment or component. Further requirements of Directive 2014/34/EU Article 13 apply to the manufacture of the equipment or component and are separately certified. Compliance with the Essential Health and Safety Requirements, with the exception of those listed in the confidential report, has been demonstrated through compliance with the following documents: EN60079-0:2012+A11:2013 EN 60079-1:2014 EN60079-11:2012 The equipment shall be marked with the following: R C Marshall Certification Officer This certificate shall only be copied 1 Of 3 in its entirety and without change www.CMLEx.com

Open the catalog to page 1
ATEX certificate for LEEG pressure transmitter - 2

Issue 0 11 Description The DMP305X-**T-*****-**-*C-*-* gauge/differential pressure transmitter is constructed from a cast aluminium alloy housing. The equipment is of a single chamber design and uses threaded end covers and threaded entries, all with sealing O-ring gasket. There is a cemented window on the front cover which is additionally secured by a clamping ring. The cmeneted joint length is greater than 10mm. The equipments naming system is below: 12 Certificate history and evaluation reports Note: Drawings that describe the equipment or component are listed in the Annex. 13 Conditions...

Open the catalog to page 2
ATEX certificate for LEEG pressure transmitter - 3

14 Specific Conditions of Use (Special Conditions) The following conditions relate to safe installation and/or use of the equipment, i. When the equipment is installed in a Zone 0 hazardous area, the end user shall protect the equipment from ignition hazards in the form of impact or friction, ii. The flameproof joints shall not be repaired. Contact the original manufacturer for information on the dimensions of the flameproof joints, iii. The intrinsically safe version of the equipment does not satisfy 500 V test of IEC 60079-11 CL 6.3.13.and shall be supplied by an isolated barrier which is...

Open the catalog to page 3

All Shanghai LEEG Instruments Co. catalogs and technical brochures

Archived catalogs