| The low cost MO9609 LVDT Monitor Module is designed to accept inputs from any LVDT or RVDT. It is ideally suited to applications where constant surveillance is required on machinery, to protect against sudden deterioration in condition and avoid costly breakdowns. Current and Voltage signal outputs are factory set as required for the specified displacement/position signal range. Adjustable level, latching or fleeting alarms may operate with either normally open or normally closed contact outputs. All these signal outputs are continuously available via the rack rear panel terminal blocks. The module uses only the highest quality components and has been extensively type tested to ensure effective monitoring and prevent spurious alarms. Up to 12 modules can fit into a standard 19" rack (3U high) with a single shared LED digital display module. Further modules in second and third racks can utilise the same display module by simple connection of the racks. The level of any particular channel is brought up on the display in percent, by depressing the 'select' button on the front of each module. An Amber LED illuminates next to the button to indicate which module is currently being displayed. Alarm levels are displayed by pressing and holding the Al or A2 buttons on the selected module. The signals available for routing to the monitor are: - a displacement signal for adjustment of zero & gain, together with alarms 1 and 2 setpoints. |