SealMaster ERX-TREME Bearing - SealMaster - #19

Text version of the page

19 Shaft Mounting Installation Procedures for Ball Bearings Note: Setscrew marks on the shaft can be removed by backing out the setscrews and using a flat punch to tap down the set screw burrs on the shaft. Setscrew Locking: Skwezloc Locking Collar: ER Installation Capscrew A B • Apply light film of oil on shaft. • Slide, do not hammer, bearing onto shaft. Place Bearing On Shaft 3 Check Alignment 5 Alternate Torquing of Setscrews 1 Inspect Shaft • Clean/remove burrs • Check diameter. See page 18. • Clean mounting surface Setscrews Alignment • Step 1: Torque setscrew “A” to 1/2 recommended torque. • Step 2: Torque setscrew “B” to full recommended torque. • Step 3: Torque setscrew “A” to full recommended torque. See page 23. 2 4 • Align setscrews on both bearings in line. • Slide, do not hammer, bearing onto shaft. Place Bearing On Shaft 3 Check Alignment 5 Tighten Capscrew to Recommended Value 1 Inspect Shaft • Clean/remove burrs • Check diameter. See page 18. • Clean mounting surface Hold Locking Collar Tightly Against Inner Ring Shoulder 2 4 ! WARNING High voltage and rotating parts may cause serious or fatal injury. Turn off power to install or service. Operate with guards in place. Read and follow all instructions. • Bearing and shaft must be in alignment. • Rotate shaft to make sure it turns smoothly. • Bearing and shaft must be in alignment. • Rotate shaft to make sure it turns smoothly.