| | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | |
| | | |
| | | FINISHING OF STEEL Low alloy steel, HB 180 | | |
| | | |
| | | WF - for productive finish turning Operations: Longitudinal turning and facing. Components: Rigid shafts, axles, hubs, gears Advantages: Double conventional feed rates 1 face iiriiSh or hnivod surface: finish v.-11 i.i ; : s fo' | | |
| | | CNMG 12 04 08-WF | | |
| | | |
| | | |
| | | -PF | |
| | | |
| | | Operations: Long
| | ■ning, facing, back-turning a' | | |
| | | |
| | | profiling. Components: Axles, gears where good surface finish is a priority. Advantages: Light cutting geometry, low cutting forces suitable for slender shafts, thin walled and unstably clamped compo- | | |
| | | |
| | | F/rst choice AVERAGE CONDITIONS | | |
| | | GOOD CONDITIONS | | | DIFFICULT CONDITIONS | | |
| | | | |
| | | |
| | | 3 | | |
| | | o ■ Continuous cuts. ■ Pre-machined or light forged skin. | | |
| | | |
| | | General purpose operations. | | |
| | | ■ Interrupted cuts. • Heavy forging scale. | | |
| | | |
| | | |
| | | |
| | | per | | |
| | | |
| | | -WF/GC4015 NORMAL FEED | | |
| | | |
| | | NORMAL FEED | | NORMAL FEED | | |
| | | |
| | | 26 | | |
| | | |
| | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | |