P NMSKH

Face milling – CoroMill

200

Heavy roughing operations

First choice LowHigh Operation stability

Coarse pitch (L) Close pitch (M) Extra close pitch (H)

Reduced number of inserts. Best productivity if stability and power are limited. Deep full slot-ting. Extended tooling. Small machines. Low cutting forces. General purpose milling and mixed production. Small to medium machines. Always first choice. Maximum number of inserts for best productivity under stable conditions. Short chipping materials. Heat resistant materials. Edging operations.

Insert geometry Workpiece material/Geometry

First choice

Medium LightHeavy ISO/ANSI

LMH SteelStainless steelCast ironHardened material

P M

For general milling in most materials.Light milling. Low cutting forces. Low feed rates.Heavy milling. High cutting forces. High feed rates.

K H

Four insert sizes are available in three geometries, covering up to 10 mm depth of cut with a feed range of 0.05 to 0.6 mm per insert.

Operations:

General facemillingShoulder millingFull slot millingRest millingProfiling

155