Vertical Sections

× 1” (unplated copper)One (1)—0.25” × 1” (tin plated copper)Two (2)—0.25”

2

Basic Sections and Structure Features/Modifications (SC-II and PE-II)

× 1” (tin plated copper)NO-OX-ID Section Features/Modifications, continued DeliveryProgram × 1” (unplated copper)For applications utilizing ground bus mounted on both top and bottom or from back-to-back line ups, two (2) ground bus splice kits are required for joining each shipping block.SC-IITwo (2)—0.25” Horizontal Ground Bus Splice KitOne (1)—0.25”
® NO-OX-ID compound on busPullbox
[1] 12” high × 15” deep or 20” deep (except corner sections)ShuttersFor isolation of plug-in stab openings—automaticFor isolation of plug-in stab openings—manualProtective CapsFor unused plug-in stab openingsUnit Isolating BarriersFor closing the wire opening between unit and vertical wirewayDeviceNet Connector CoversFor covering the unused DeviceNet connectors manufacturer in the vertical wireway of a DeviceNet MCCWireway Tie BarsFive (5) cable tie bars in vertical wirewayOutgoing Equipment Ground LugOne (1) #6-250 kcmil lug mounted on horizontal ground bus in addition to lug providedT-HandleT-handle latch on vertical wireway doorMaster NameplatesLocated on top horizontal wireway cover of the second vertical section in lineup, 2” × 6”Stainless Steel Nameplate ScrewsStainless steel nameplate screws for master nameplate (2 per nameplate)SC-II (+2 days)External Mounting Channel
[2] Two (2) 1.5” × 3” mounting channels NOTE: Adding an external mounting channel will add 1.5” to height of sectionSC-IINEMA Type 3R Lifting AngleOptional lifting angle for NEMA Type 3R industrial cabinets only. This angle is not removable.PE-II Space heaters and ThermostatSpace heater with thermostat in each section200 watt, 120 volt strip heater. Thermostat set at 70 ° F ( 21 ° C ). SC-IIFor two-section shipping block, one space heater is supplied in each section with a single thermostat control located in right-hand sectionFor three-section shipping block, one space heater is supplied in each section with a single thermostat control located in center sectionSpace heater with thermostat in each section200 watt, 240 volt strip heater. Thermostat set at 70 For two-section shipping block, one space heater is supplied in each section with a single thermostat control located in right-hand sectionFor three-section shipping block, one space heater is supplied in each section with a single thermostat control located in center sectionExport Packing Below Deck for SectionsMaximum 3-section shipping block. Shipping block is skid mounted and packaged in poly wrap. Packing is not watertight or waterproof. Skid is 2” ° F ( 21 ° C ). × 8” construction according to shipping block size. Top is 2” × 4” frame with 0.438” orientated strand board (OSB). Ends and sides covered with 0.438” orientated strand board (OSB) with 2” × 4” cross members. Two steel bands around outside of container. Extended storage may require space industrial heaters and other considerations.SC-II
[3] [1]Available on NEMA Type 1, Type 1 with gasket, and Type 12 sections only. [2]External mounting channel is shipped attached to MCC section(s). [3]Additional time required for export packing of SC-II and PE-II sections.

26