Pressure regulators Type RP500 - RIBA SPECKEN DRUMAG - #1

Text version of the page

Untitled table.main {} tr.row {} td.cell {} div.block {} div.paragraph {} .font0 { font:5.95pt "Arial", sans-serif; } .font1 { font:9.00pt "Arial", sans-serif; } .font2 { font:14.00pt "Arial", sans-serif; } .font3 { font:29.00pt "Arial", sans-serif; } Type RP500 Technical data Voltage..........................24 VDC ±10 % Power consumption, electrical...........4.5 W max. Connection, electrical.................terminal- or customer-sp. connector Pressure supply.....................25 bar max. Pressure range ..................... 0 to 24 bar Medium..........................compressed air, oiled, on-oiled, neutral gasses, filtered 50 pm Air consumption ....................no permanent air consumption Flow............................4100 l/min at an input pressure of 6 bar Connection thread...................G 1/2" (1 + 2) Connection thread, manometer..........G 1/4" (2) Ingress protection...................IP 67 Operating temperature range ...........-5 to +50 °C Hysteresis ........................< 0.2 % of the corresponding range Repeatability ......................< 0.2 % of the corresponding range Weight ..........................1.2 kg Type key Sample order RP500 with a pressure range of 0 to 10 bar, control signal 0-10 V, analog circuit board, Fail Safe = pressureless, with external sensor 4-20mA Order code: RP500/0-10/1/A/2/E3 Pressure range Control range 0 to 24 bar Précision pressure regulator 1/2" connection This pressure controller serves to control high flow rates of up to 250 m3/h at 6 bar. The large cross-section of the secondary vent also ensures fast evacuation or adaptation of the secondary pressure, also for large volumes. A sensor in the outlet section monitors the discharge pressure which is constantly compared with the set value. Deviations are adjusted quickly and accurately. Set value input (Control signal) 1 2 3 P M C 0-10 V 0-20 mA 4-20 mA Profibus-DP Modbus CanBus I Interbus S D Device-Net R RS232 S RS485 T set-point potentiometer on the housing (free of potential on request, other analog areas on request) Version A Analog circuit board - M Digital microprocessor circuit board Fail Safe (in case of power failure) 1 pressure maintenance 2 pressureless - Options N no option E actual value input E1 = 0-10 V, E2 = 0-20 mA, E3 = 4-20 mA G potential isolation in set value input S soft start after EMERGENCY OFF (3 secs.) Actual value output The response signal corresponds to the range of the control signal. Other ranges on request. RIBA > 11