PAXI - Red Lion Controls - #3

Text version of the page

3 GENERAL METER SPECIFICATIONS 1. DISPLAY: 6 digit, 0.56" (14.2 mm) red sunlight readable or standard green LED 2. POWER: AC Versions: AC Power: 85 to 250 VAC, 50/60 Hz, 18 VA Isolation: 2300 Vrms for 1 min. to all inputs and outputs. (300 V working) DC Versions: DC Power: 11 to 36 VDC, 14 W (derate operating temperature to 40° C if operating <15 VDC and three plug-in option cards are installed) AC Power: 24 VAC, ± 10%, 50/60 Hz, 15 VA Isolation: 500 Vrms for 1 min. to all inputs and outputs (50 V working). 3. SENSOR POWER: 12 VDC, ±10%, 100 mA max. Short circuit protected 4. KEYPAD: 3 programmable function keys, 5 keys total 5. USER INPUTS: Three programmable user inputs Max. Continuous Input: 30 VDC Isolation To Sensor Input Commons: Not isolated Logic State: Jumper selectable for sink/source logic Response Time: 6 msec. typical; function dependent. Certain resets, stores and inhibits respond within 25 ìsec if an edge occurs with the associated counter or within 6 msec if no count edge occurs with the associated counter. These functions include ƒ³ƒäƒâƒÃƒäƒ¼, ƒ³ƒäƒâƒÃƒäƒµ, ƒ¸ƒ¼ƒâƒÃƒäƒ¼, ƒ¸ƒ¼ƒâƒÃƒäƒµ, ƒ¹ƒ¾ƒ¸ƒ¹ƒÒƒä, ƒÃƒäƒ¿ƒâƒµ, and ƒÀƒâƒ¾ƒâƒÃƒä. Once activated, all functions are latched for 50 msec min. to 100 msec max. After that period, another edge/level may be recognized. 6. MEMORY: Nonvolatile E2PROM retains all programmable parameters and display values. 7. CERTIFICATIONS AND COMPLIANCES: SAFETY UL Recognized Component, File #E179259, UL61010A-1, CSA C22.2 No. 1010-1 Recognized to U.S. and Canadian requirements under the Component Recognition Program of Underwriters Laboratories, Inc. UL Listed, File #E137808, UL508, CSA C22.2 No. 14-M95 LISTED by Und. Lab. Inc. to U.S. and Canadian safety standards Type 4X Enclosure rating (Face only), UL50 IECEE CB Scheme Test Report #04ME11209-20041018 Issued by Underwriters Laboratories, Inc. IEC 61010-1, EN 61010-1: Safety requirements for electrical equipment for measurement, control, and laboratory use, Part 1. IP65 Enclosure rating (Face only), IEC 529 IP20 Enclosure rating (Rear of unit), IEC 529 ELECTROMAGNETIC COMPATIBILITY Note: Refer to EMC Installation Guidelines section of the bulletin for additional information. 8. ENVIRONMENTAL CONDITIONS: Operating Temperature Range: 0 to 50°C (0 to 45°C with all three plug-in cards installed) Storage Temperature Range: -40 to 60°C Operating and Storage Humidity: 0 to 85% max. relative humidity noncondensing Vibration According to IEC 68-2-6: Operational 5 to 150 Hz, in X, Y, Z direction for 1.5 hours, 2 g’s. Shock According to IEC 68-2-27: Operational 25 g's (10 g's relay), 11 msec in 3 directions. Altitude: Up to 2000 meters 9. CONNECTIONS: High compression cage-clamp terminal block Wire Strip Length: 0.3" (7.5 mm) Wire Gage: 30-14 AWG copper wire Torque: 4.5 inch-lbs (0.51 N-m) max. 10. CONSTRUCTION: This unit is rated for NEMA 4X/IP65 outdoor use. IP20 Touch safe. Installation Category II, Pollution Degree 2. One piece bezel/case. Flame resistant. Synthetic rubber keypad. Panel gasket and mounting clip included. 11. WEIGHT: 10.1 oz. (286 g) Inactive VIN > 3.6 VDC VIN 3.6 VDC SINKING INPUTS 5.1 KƒÇ pull-up to +12 V SOURCING INPUTS INPUT STATE 5.1 KƒÇ pull-down Power mains class A RF interference EN 55011 Enclosure class A Emissions to EN 50081-2 150 KHz - 80 MHz RF conducted interference EN 61000-4-6 Level 3; 10 V/rms Level 3; 2 Kv power Fast transients (burst) EN 61000-4-4 Level 4; 2 Kv I/O 80 MHz - 1 GHz Electromagnetic RF fields EN 61000-4-3 Level 3; 10 V/m Level 3; 8 Kv air Electrostatic discharge EN 61000-4-2 Level 2; 4 Kv contact 200 Hz, 50% duty cycle 900 MHz „b5 MHz Immunity to EN 50082-2 Simulation of cordless telephones ENV 50204 Level 3; 10 V/m