RAS MULTIBEND-CENTER - RAS Reinhardt Maschinenbau - #4

Text version of the page

The runout extension moves the finished part to the multiple finished part buffer. The main manipulator positions and rotates the blank with an accuracy of 0.001 degree. Highly dynamic folding beam The "Magic-Eye" system scans the position of the blank. 4 RAS 79.22-2 / RAS 79.26-2 Material handling: accurate, fast, flexible! Multibend-Center Precise scanning Once a blank is loaded into the Multibend-Center the „Magic-Eye“ Scanner optically measures the blank. This precision measuring technology is able to scan the most complicated notches, tapered blanks and even very thin parts without touching the part itself. All of this happens simultaneously to the production time of the previous part and therefore without any delay from part to part. After the actual blank position has been determined, the load and main manipulator automatically compensate any off-set that may be needed. Quick supply After scanning, the blank arrives at the main manipulator. It clamps and positions the part during the entire folding sequence. With the blank being scanned outside of the folding area, the typical part-to-part time is just approximately 4 seconds. The main manipulator rotates the blank to any angle with an accuracy of 0.001 degree. No operator can be this accurate, no matter how experienced! This results in precision parts … extremely accurate and infinitely repeatable. Flexible unloading Finished workpieces can be unloaded by many different options. The Multibend-Center can deliver the part back to the operator or pass them through to the other side of the machine. At the end of the runout system, the operator can pick the parts from a buffer table, or an intelligent unload robot can pick and stack the workpiece.