Pulsarguard 2010 solids flow monitor - Pulsar Process Measurement - #1

PU LSARguard

The 2010 series of process protection units use patented state of art soundwave technology, to detect changes in structure borne acoustic emissions from equipment and materials in motion. The sensor listens to noise caused by impacts, cavitation and friction within structures, on a wide frequency band width of 100 to 600kHz, making it sensitive to the slightest changes in process conditions, but also being immune to audible noise or vibration caused by plant machinery. Instant reaction to How changes provides protection plant operation or other abnormal flow conditions in pipes, supply lines, chutes and feed mechanisms.

bo

Co

The 2010 sensor series is designed with the operator in mind. Powered with 23 to 30 Vdc the sensor provides a 0 to 10 volt output, this signal may be fed directly to a PLC, or the optional control unit 2020 shown overleaf.

Typical Applications ■Burst fitter bag detection •Detects impending blockages

• Detects flow & no flow

• Detects pump cavitation •Value leakage detection

•Detects Bridging or Ratholing in silos •Material flow/route verification

As the sensor is completely non-invasive there is no need to shut down the process to install the sensor. By using the 14mm bolt hole in the tab it may be installed in minutes. Their compact design means that it can be fitted in the tightest of positions or environments.

3

• Non invasive

•Simple bolt on installation

• Low cost

• No moving parts

• IP 68 Stainless Steel housing •Maintenance free

•Highly reliable in low or high temperatures

• Flammable atmosphere approved '2010' option