Digital protection test set-PNS801
2Pages

{{requestButtons}}

Catalog excerpts

Digital protection test set-PNS801 - 1

PW460 Specification PNF801 Fiber Digital Protection Tester 1.3 Device Features 8 fiber optical ports for: Receiving and sending IEC671850-9-2 format SV and GOOSE message PNF801 Receiving and sending IEE1588 message Measuring received fiber optical power Provide flexibility to configure both SV (IEC61850-9-2) and GOOSE ports independently. Each port can be configured as Receive and Send at the same time or it can be configured as Receive or Send. Strong data receiving and sending capability for each fiber optical port: Can send 6 groups of SV at the same time Can send 12 groups of GOOSE at the same time Can receive 5 groups of GOOSE message Fiber-optic port Main power IEC60044-7/8 port Can send/receive IEE1588 message While sending SV, the dispersion of the MU is better than ±80ns Can receive SV, realizing self-loop test Fiber-optic communication ports from NO.1~NO.4 can be used to measure received optical power 8 independent meeting IEC60044-7/8(FT3) format SV output port Can simulate collector and output meeting IEC60044-8 format message Ethernet port to MU Low-level Signal Analog Output GPS antenna connection port IRIG-B synchronizaion port 12 configurable independent low-level analog signal output terminals, Binary inputs Binary outputs can be used to test the low-level signal input protection device Can publish/subscribe many different GOOSE control block message Analyze protection model file (SCD、ICD、CID、NPIautomatically Can configure SV, sample channel message, GOOSE message automatically Can check the GOOSE communication link SV, GOOSE configure message can be saved and recall repeatedly PNF801 Front and real panels Simulate the abnormal massage (jitter, frame loss, flying spot, wrong sequence, data anomalies, packet retransmission, channel invalid, out of step, etc.) Software can communicate with the protection device directly Read protection value, SV report and the other message by MMS Provide IEEE1588 based Ethernet synchronization capability and the synchronization error is less than ±80ns www.ponovo.com.cn IRIG-B synchronization port and built-in GPS synchronization mechanism

Open the catalog to page 1
Digital protection test set-PNS801 - 2

Technical Parameters Power Supply_ Ethernet Communication Interface Ethernet cum mimici inn purl: I'm aim mu nient inn wi rstegoryi twisted pair Rear panol FT3 inter fare: erface type Low-level Signal Analog Output Time reM.Vlu.lion Eleetriral isolation Threshold imperlar nput eléctrica] isolatio: nply contacts, regardless of pülarily [Miliwarc control)_ Synchronization Interface In M rum e m prin i de-, ih ver u ay '¡I S\ iu:i:i:i: i/al inn mirri are; • ILLL 158Bsynchruil¡i¡iliui]: any fiber-optic communications

Open the catalog to page 2

All PONOVO POWER CO. catalogs and technical brochures

  1. PW636i

    22 Pages

  2. PW-VP50

    2 Pages

  3. PW636i-F

    21 Pages

  4. PNS630

    6 Pages

  5. NF802

    6 Pages

  6. DC test kit

    2 Pages

  7. RTDS Amplifier

    10 Pages

  8. PONOVO

    44 Pages

  9. STATCOM

    12 Pages

  10. CT Analyzer

    1 Pages

  11. DC test set

    2 Pages