Text version of the page

Installation with acouSTIC â–  Cut end of adhesive tube to producea â–  Make sure both the panels and thesurface to which the panels are being applied are dust- and dirt-free. If adhering to a metal surface, use a degreaser.

Pintaacoustic - General Catalog - 22406 acouSTIC

™

Adhesive Product Information and Installation Guide

1 /
4 " bead. â–  First apply a
1 /
4 "-line of adhesive around the perimeter of the panel approximately 1" from the edge. â–  Next, apply a
1 /
4 "-line of adhesive from opposite corners through the center of the panel, creating an “X.” General Installation Notes â–  Handle with care. Do not pick up or handle panels or tiles by the corners. acouSTIC adhesive (part number PA-02) from pinta acoustic, inc. has been specially formulated to use with SONEX â–  For best results, cut panels from flat side. â–  â–  Store right side up and flat in aclean, dry area protected from the elements. Do not sit on, or stack anything on top of cartons. Work with clean hands on a clean work surface. Wear clean cotton/ canvas gloves for installation. â–  To create visual flow of theSONEXvalueline Features
® â–  Use a sharp razor or fixed bladeknife and a metal straight-edge to cut panels or tiles. The blade should be long and sharp enough to cut through the entire thickness of the foam. An electric carving knife works well. Panels, FABRITEC
™ WallPanels, CONTOUR
® Tiles andPROSPEC
® Foams and Composites.This nontoxic, water-based adhesive makes installation hassle-free and provides a strong, permanent bond when adhering. Other adhesives may not be compatible with pinta products and may emit an odor. â–  â–  Press panel into place and hold for 5seconds. Then pull panel away from the surface for 1 minute to allow adhesive to become tacky. Press the panel back into positionand hold again for 5 seconds. â–  Nontoxic, water-based adhesive â–  Easy clean-up with soap and water â–  Compatible with both polyurethaneand willtec
® foams
™ pattern, space each panel 1" from adjacent panels. â–  Each 10.5-ounce tube installs up to32 square feet of product â–  â–  When installing SONEXclassic Overhead installations may require additional support and cure time until adhesive sets.
™ â–  Available in case quantities of 24 tubes or SONEXjuniors
™ , alternate themale and female patterns for a checkerboard look or install with 1" space between similar adjacent panels. â–  Tube fits standard caulking guns orcan be used with pinta’s applicator gun (part number PA-01)
3800 Washington Avenue North â–  Minneapolis, MN 55412 â–  Toll-Free 1-800-662-0032 â–  sales@pinta-acoustic.com â–  www.pinta-acoustic.com © 2007 pinta elements GmbH. All rights reserved. 06/07 pinta acoustic, inc. is a company of pinta elements GmbH.